How to hotwire 1996 mercury sable

SOURCE: 1996 mercury sable speed hand and drives in strain and ****

I hace a 19196 sable-the problem is the transaxle speed sensor-this part sends all speed info to the computer ..-First symptom(speedometer stops working and then transmission shifts erratacially and power steering becomes hard and engine light comes on..The computer on this all eletronic car cannot send proper signals to the speedo-trans-power steering and other functions without knowing how fast or slow the car is going..Have the SPEED SENSOR mounted on top of the tranaxle replaced and all will be well.Part is not to expensive.labor can vary depending whether you have 3.0OHV or DOHC engine-some cars have to have exhaust dropped to get at it-Good Luck All

SOURCE: 5 digit code to unlock my 1997 Mercury Sable

It is located on the keyless entry module located under the drivers side dash. There will be a five digit code on the side of the box facing the passenger side. Enter the code and it should unlock. Follow owners manual to change the code, it will store both codes at the same time and either should work.

SOURCE: 1996 Mercury Sable LS. Problem: Dome light and

have you checked to make sure the dimmer switch isn't turned all the way up? if the dimmer is turned all the way up it will keep the lights inside the car on. check the dimmer switch

Marvin

• 85242 Answers
• Posted on May 15, 2009

SOURCE: 1996 Mercury Sable

go to the link below and follow it to a PDF of your owners manual, the fuse box info is in the owners manual.
http://www.edmunds.com/ownership/howto/articles/120189/article.html

SOURCE: 1996 Mercury Sable possible ignition problem. The

may be your ignition lock cylinder broke inside, either way, it's not that expensive to fix.