Question about 1992 Oldsmobile 88

1 Answer

How do I replace the driver side rear transmission mount?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Oldsmobile Master
  • 15,575 Answers

Front wheel drive or rear wheel drive ? You need a good jack , a floor jack would be best . Do you have Jack stands an a floor jack ? You need to get it up in the air a little so you can get under it . You will need to put the jack under the transmission an jack it up just enough to take the pressure off the mount . Un bolt the old one , put the new one in bolt it an torque it to spec.

Posted on May 25, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: Brake shoe positioning on -88 K2500

Short shoe goes towards front. Also: check for any contamination on shoes or hardware from either axle seal or wheel cyls. Any contamination will make vehicle pull when brake applied. Technically, if contaminated shoes need replacement but if not heavy, on new shoes I usually just give a light sanding on friction material and the remainder will usually burn off.

Posted on Feb 12, 2009

morse008
  • 1111 Answers

SOURCE: I am replacing the engine mounts on my 1997 Buick

it is attached there to the cross member

Posted on Sep 21, 2009

wilsodfarm
  • 986 Answers

SOURCE: which side of the car is the starter on, drivers

right side held with two 9/16 bolt heads

Posted on Nov 26, 2009

Testimonial: "Very helpful, Thank You "

csmock132
  • 4669 Answers

SOURCE: infl. rest.

The inflatable restraint is the air bag

Posted on Apr 01, 2010

honeymokey
  • 3113 Answers

SOURCE: transmission is slipping really bad

Automatic Transmission, THM440-T4 Initial Fill..........6.1 quarts
Automatic Transmission, Total Fill
4 speed THM440-T4..........10.1 quarts

Posted on Apr 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace speed sensor


the speed sensor is located on the rear output housing of the transmission. It is a sensor mounted on one of the sides right before your drive-shaft exits the transmission. look for ta wire coming from the rear of your transmission. Easy replacement.

Feb 26, 2013 | 2000 Jeep Cherokee

1 Answer

I need to know where they are locatedhow to install ****** & motor mounts on a 1996 buick century


the transmission mount is on the top of the transmission on the drivers side next to the battery,and one motor mount is under the motor on the passenger side next to the harmonic balancer. and the is either one or two mounts on top of the radiator to the front vavle cover

Nov 05, 2012 | 1996 Buick Century

3 Answers

Where is the crank shaft position sensor on a 2002 Jeep crank shaft position sensor


in the transmission bell housing, passenger side at about 11o'clock if looking from the front.

Feb 27, 2011 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Where is dipstick for transmission on 08 tundra 4.7 liter?


If it's an Automatic and the engine is mounted Sideways then the dipstick for the transmission is located on the drivers side somewhere near the point where the Engine and Transmission come together or the Front of the transmission. If the motor is mounted in a regular fashion, motor in front then transmission under the car, the Dipstick is located near the firewall at the rear of the motor. If this is a Manual transmission there is no Dipstick.

Dec 22, 2010 | Toyota Tundra Cars & Trucks

2 Answers

Location of the temperature sending unit on a 1991 olds toronado


Ok, you have three sensors on this engine that work together to manage the temperature reading that are sent to the gauge. i recommend checking all three to be safe. i will list the sensors and, locations below.

1. Coolant temperature sensor- Under hood, driver side, upper engine area, above transmission bell housing, mounted in driver side end of intake manifold.

2. Engine Temperature sensor- Under hood, driver side, upper engine area, mounted on rear cylinder head

3. Temperature switch.- Under hood, center, lower engine area, above oil filter, rear of coolant temperature sensor, mounted in engine block




Jul 09, 2009 | 1991 Oldsmobile Toronado

3 Answers

Location of motor mounts on 94 saturn sl1 where are they and how do you replace them? (all of them) or at least the major ones


There are four total mounts.

1. Upper engine mount located on the passenger side of the engine. Get this at the dealer, aftermarket, especially Anchor brand are garbage.

2. Lower engine mount, often refered to as a "dog bone" mount because of its shape. This one is located on the lower passenger side. You'll have to remove some splash shields to get to it. Aftermarket is OK.

3. Upper transmission mount, also refered to as a "dog bone" mount. Located under the battery.Aftermarket is OK.

4. Lower transmission mount. Located under the transmission. As with the top engine mount, dealer is better quality.

The two dogbone mounts usualy last a very long time, its the others that fail over time. Especially the upper one.

Jun 17, 2009 | 1999 Saturn SL

2 Answers

97 jeep Crankshaft Position (CKP) Sensor . . . 4 cyl motor . . . where is it? No not the motor . . .the CKP! Thanks


NOTE: The crankshaft position (CKP) sensor is mounted to the transmission bellhousing at the left/rear side of the engine block.
  1. The sensor may be mounted to the transmission with one of the following configurations:
    • One bolt: If the sensor is equipped with one mounting bolt, it is adjustable.
    • Two nuts
    • Two bolts
  2. Near right-rear side of engine
Please don't forget to rate!!!!

Mar 31, 2009 | 1997 Jeep Tj

1 Answer

2001 cavalier manual trans


Jack the car up, take the drivers side tire off. It's mounted to the drivers side rear section of the transmission, axel high, follow the wires.
Not on the top of the transmission like some books say.

Nov 05, 2008 | 2001 Chevrolet Cavalier

3 Answers

Motor mount


The engine mounts are located about the middle of the block on the side of the engine. The only other mount is located under transmission.

Jun 09, 2008 | 1998 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...