SOURCE: Range Rover p38 bmw 2.5 injection running problem
Hello,
It turned out to be a broken wire on the injector which was causing a bad connection,now running better than before.
The cold was just a coincidence.
Thank you and best regards,Yvonne
SOURCE: location of the fuel filter P38 4.6 Range Rover 1999
The last one of these I saw the filter was in the tank.This is after checking the manual that said it was in the RH rear wheel arch.
SOURCE: My P38 Range Rover wont start
Hi Adam,
Bring your vehicle to an auto parts or battery store. Ask if they could perform a 'Load Check' on your battery. This not only checks the voltage, but also the amps, as if it were under the load of turning your engine.
It takes a few seconds and the results are pass or fail. Fail means it's time for a new battery. Pass means we need to look elsewhere.
Comment back the results.
Hope you find this to be very helpful
Mike
SOURCE: Range Rover p38 we have just fitted a new battery
check the fuse first ,look up cigarette lighter fuses first i bet that is blown ,cos that fuse is part of cigertte lighter and ur stereo aas well also check ur heater fuses as well
SOURCE: how do i change drive belt on p38 range rover
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I have only been a free contributor to this site for the past 4-months.
Not sure if this what you need for the "P38" but it is for the 1996 Range Rover.
I do not know if you still need this information, but I am going ahead and answering it anyway.
Click on the following Link. It has the several Serpentine Belt Diagrams, one of which matches your specific vehicle with your particular options (AC, Power Steering etc..).
Regarding HOW:
Standard Rule to Removal the Serpentine Belt:
1. Find the Tensioner(s). (See Diagrams on Link)
2. Rotate/Move the Tensioner away from contact with the belt and towards the area where the belt is not in contact with the Tensioner Pulley. The Tensioner is spring loaded, and is hard to rotate/move.
3. Remove the loosened belt off one of the other more easily accessed Pulleys.
Standard Rules for Installing the Serpentine Belt:
a. Pick a Pulley that is most easily accessed. This will usually be on top. This will be the last Pulley that the belt will go on.
b. Using the Diagram: Install the new Serpentine Belt on the remainder of the Pulleys....over, under, left right.
c. Using a Serpentine Belt Tensioner Tool or Wrench or Ratchet Tool: Rotate/Move the Tensioner Pulley/Arm "away" from Belt contact area on the Tensioner. This spring is pretty hard and with a new belt, it will be even harder to install. Rotate/Move this to as-close to the maximum allowed inorder to have enough slack in the belt to get it up and over the last pulley.
d. Using your other hand - Pull the Belt up and over the Last remaining Pulley.
e. Before releasing the pressure on the Tensioner, visually inspect the remainder Pulleys and the Belts' Positioning on them.
Let me know if this helped...
http://www.2carpros.com/car_repair_information/year/1996/make/land_rover/model/range_rover/1996_land_rover_range_rover_drive_belt_routing_diagram.htm
130 views
Usually answered in minutes!
×