Hi Edward,here's a cool Honda parts store,even shows pics,I use this site,you can look up both vehicles and see if the part number is the same on both Honda's for the seats. Shop for Honda Parts
SOURCE: honda accord 96 exi
You need to discharge the AC system and remove the evaporator to replace the
expansion valve. No two way about it.
No need to remove the dash
SOURCE: oil filter in civic 97
If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))
Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.
Please don't forget to rate:)
SOURCE: power window on a 97 honda accord wont go up
possibly your power window regulator is out. basically check the fuses first to make sure you have not blown that, if it is good, then you can order a new window regulator from the dealer or online @ autopartswarehouse.com. to replace the window regulator you will need to will need to remove the door panel, start with the screws on the handle and the arm rest, covered with a plastic cap. the door panel which can be pryed from the bottom with a flat blade screw driver or flat pry bar, it will make a snapping sound. three bolts on the regulator 4 bolts on the window tracks and 2 bolts securing the window, re assemble as you have taken apart, Good Luck!!
SOURCE: how to replace seat belt buckle on Honda? civic
This rtequires seat removal in order to gain acces to the buck side mounting bolt
Testimonial: "Very helpfull"
SOURCE: Torque specs for 96 Honda Accord 2.2L
the main bearings bolts is to 1st step 30Nm or 22lbs ft and the last step is 75Nm or 54lbs ft in this tighten secuence. 9 3 1 5 7 on the top bolts and........ ........ ........ ... 8 6 2 4 10 botton bolts and the connecting rod 45Nm or 34 lbs ft i hope be help you
156 views
Usually answered in minutes!
×