SOURCE: how to flush and change the antifreeze on a 2001 mercury grand ma
loosen pressure cap slowly at coolant tank to relieve pressure,when pressure is relieved remove cap,place a suitable container under drain valve at bottom of radiator open drain valve.when coolant has stopped draining,close valve.then remove thermostat,[this is a good time to replace t.stat since it must be removed to refill cooling system],disconnect heater core coolant supply hose at rear of intake manifold.add coolant thru t.stat opening until coolant comes out of coolant supply hose fitting,reinstall hose and tighten[not to tight] reinstall thermostat o ring and thermostat.add coolant to tank until the coolant level is between the COOLANT FILL LEVEL marks.select the maximum heater temperature and blower speed settings run engine until it reaches operating temp.add coolant until the coolant level is between the COOLANT FILL LEVEL marks.turn off engine allow it to cool, recheck coolant level,add as needed .ford requires this procedure to avoid engine damage due to trapped air.
SOURCE: how to replace starter +1993 Mercury Grand Marquis
disconnect battery,,jack car up,,put jack stand on frame,,take starter bolts out,(may not be easy),,take wires off starter,,hoped it helped,,
SOURCE: how do you replace headlight
you have to remove the whole lens usually two bolts onrad upper rad support remove grill and rmove lens unitturn on headlight mark which bulb to take out looking at other side light
SOURCE: heater and airconditioner control on mercery grand marquis
If the fan will not run on ANY speed in your Grand Marquis, the problem is most likely NOT the control switch.
Check for power and ground at the blower motor connector. If power and ground is present, replace the blower motor. Otherwise, the problem is most likely a failed blower speed control module (VERY common). The blower motor speed controller is located in the A/C evaporator housing just below the heater hoses.
Note: It is also common for a bad blower motor to CAUSE the controller to go bad. You MAY have to replace BOTH.
165 views
Usually answered in minutes!
Please explain what you mean by "pulsator."
×