How do you reset reset the service light on a Bmw 320, 2008 model

2010-2015 BMW X1 Service Oil Light Reset: 2010 2015 BMW X1 Service Oil Light Reset


Scroll down page on the above link to 2010-2015 BMW X1 for instructions.

How to reset BMW 3-serie E90 service lights. Automatic ...

? 12:03
www.youtube.com/watch?v=4pKz4-9r7ik
Oct 28, 2013 - Uploaded by Peter Finn How to check and reset service info lights BMW 3 serieE90.Years 2005 to 2012. Car is 320i gasoline and ...

You dont specify if its a time or distance based service...heres the distance based anyway
>

Here you go:

This can only be done with a B.M.W service tool,try a motor factors for one they don`t cost much and do all B.M.W`s(charge your mates for a lights out soon make ur money back!!!!!!!)

the brake fluid sensor will reset on its own but that model has pad wear sensors are you sure its not for that?

BMW Model E39 built from 1996~2000 will have a port like the one shown below. A Reset tool like a Peake R5 or R5-FCX is needed to reset the oil service or inspection service lights after required service.

1) If you have a reset tool then turn your car key to Position II but do not start the car.
2) Turn the cap counter clock wise on the Data Link Connector and insert the Reset Tool
3) Follow the instructions of your reset tool, different models may have different functions however they all create a short in PIN 7 to PIN 19 for a given amount of time.

OIL Service Reset requires pin 7 and 19 to be closed for 3+ seconds

INSPECTION Service Reset requires pin 7 and 19 to be closed for 10+ seconds

4) Once done, remove the reset tool and close the cap .
5) Your dash should light up with green lights at this point.
If the light did NOT reset after the above steps then you might be resetting Oil Service however an Inspection Service is needed.

this needs to be done with a european capable scan tool,check around to see if someone has this tool, no other way sorry

the brake pad warning light is controlled by a sensor located in the front and rear brake pads, small contact with 2 wires that plud into a harness, if they are bad I think the replacement cost is around 5-10 dollars for a new one, there will only be one in the front and one in the rear, the service light is turned out by a special tool at the dealer

You need a hand scaner/reset to reset the lites on this model. You can buy them on ebay or goto your local part store. Removing the lite is also handy