Would like to know what to buy and where is the part located . Thank you
Felix: Code p0444 indicates a LARGE leak, which often indicates a loose gas cap. It could also be the wrong kind of gas cap. Since they are cheap, this is where I would start.
According to http://www.obd-codes.com/p0444 :
On vehicles equipped with Evaporative emission control systems also known as EVAP, the engine draws in excessive fuel vapors from the gas tank that would otherwise be vented into the atmosphere.
The fuel vapor is routed through a vacuum line to the engine's intake and the purge valve/solenoid meters the desired amount of fuel vapors, controlled by the vehicles powertrain control module (PCM) or engine control module (ECM). The PCM/ECM monitors the voltage to the purge control valve and has detected no voltage change with the purge valve commanded on.
Note: This code is similar to codes P0443 and P0445.
Symptoms
Symptoms of a P0444 trouble code may include:
Potential Causes
Causes of this DTC may include:
Diagnostic Steps for P0444 DTC
Engine wiring harness - Check all connectors to ensure they are plugged in properly, look for loose or damaged wires. Typically the purge control valve is energized by the the battery and triggered on and off with a duty cycle through the PCM/ECM. Using the manufacturers wiring diagrams, identify which type of circuit being used and check for battery voltage presence with the key on/engine off at the power side of the control solenoid connector using a digital volt ohm meter (DVOM) set to the volts scale. If no battery voltage is present, trace the wiring back and determine the cause for voltage loss.
Test for continuity of the control side of the wire harness after disconnecting the plug from the control valve solenoid and the PCM wiring harness. Identify the correct wire at the PCM and control valve harness and check for continuity using the ohms scale on the DVOM, if excessive resistance is found, repair the circuit. If there is no continuity on the circuit, check all connections for damaged wiring, loose pins or disconnected harnesses and repair the circuit.
Purge control solenoid - Check for continuity at the purge control solenoid connector pins after removing the harness plug using the DVOM set to the ohms scale. Verify resistance is within manufacturers specifications. If no continuity is present, suspect the solenoid is internally open and replace the part with a known good unit.
PCM/ECM malfunction - Since the EVAP is only turned on during certain driving conditions, it will be necessary to monitor the EVAP control operation using an advanced scan tool capable and performing a road test under the driving conditions required to activate the EVAP system. Some advanced scan tools have an internal test to activate the EVAP system manually. Verify the PCM/ECM is commanding the EVAP system on. If the system is functioning correctly, it will be necessary to back probe the PCM/ECM wiring harness connector using a graphing multimeter or oscilloscope with a duty cycle feature with the positive lead on the purge control valve pin and the negative lead connected to a known good ground. The duty cycle should match what is commanded on by the PCM/ECM during EVAP operation. If there is no duty cycle present, the PCM/ECM may be at fault.This diagnostic trouble code (DTC) is a generic OBD-II powertrain code. It is considered generic because it applies to all makes and models of vehicles (1996-newer), although specific repair steps may vary depending on the model.a evaporative malfunction . purge valve and gas cap.
If you have to replace the purge valve, here is a picture of its location: 
---------------
If=====
If
596 views
Usually answered in minutes!
×