2005 Acura TL Logo

Related Topics:

Genos McRae Posted on May 14, 2015
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2005 acura tl, my wipers don't work, motor is good, fuses are good, only the sprayer work

  • Genos McRae
    Genos McRae May 14, 2015

    How do I check if the switch has power

×

1 Answer

Jay Plesset

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Acura Master 2,942 Answers
  • Posted on May 14, 2015
Jay Plesset
Acura Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: May 30, 2010
Answers
2942
Questions
2
Helped
668609
Points
9879

This is a classic trouble shooting issue. You need to "follow" the electricity by testing that the wiper switch has power, that it turns power on/off, and then that the motor gets power when the switch is on. If that all tests good, the last bits include testing that the motor is properly grounded, and that if you manually turn the motor, the wipers move.

  • Jay Plesset May 14, 2015

    How do you test? Use a test light like this one:http://www.tooltopia.com/equus-3410.aspx...

×

4 Related Answers

Anonymous

  • 8 Answers
  • Posted on Sep 21, 2008

SOURCE: 2005 Acura tl brake replacement

The Brembos that come on Type S/Manual models wear fast. I've changed them at 20,000 miles. They are expensive also.

Non-Type S/Manual models I have seen go 80,000 miles. The biggest factor on brake wear is how the vehicle is driven.

At 50,000 miles I would have them inspected. Depending on where you go, make sure you get an accurate measurement of both pads (inboard and outboard). 2mm is the service limit and about that time the indicators start making noise, but not always. Most indepent shops are going to sell you brake pads at 4mm. That's another 10,000 miles at least you could have driven on them.

Never replace just the brake pads, resurface or replace the rotors. The uneven surfaces of the rotor will cause your new pads to wear incorrectly and possibly cause brake noise. Most aftermarket pads will cause a squeel.

Ad

Anonymous

  • 14 Answers
  • Posted on Jan 04, 2009

SOURCE: how to change spark plugs on 2005 acura tl

Hi,

you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.

find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.

emissionwiz

Marvin

  • 85242 Answers
  • Posted on May 22, 2009

SOURCE: 2005 Acura TL Fuel Filter

the fuel filter for this is in the gas tank, it is part of the fuel pump module.

Anonymous

  • 5 Answers
  • Posted on Aug 28, 2009

SOURCE: Disc read error on my 2005 acura TL gps

Was the door open when you got the message (easy to do)?
Did you close the door properly?
Did you replace the disc shiny side down?

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

1997 Acura 2.5 TL wiper fuse keeps blowing

weak or faulty wiper motor, or wiper motor under heavy load, clean out snow ice and debri then retry wipers.
0helpful
1answer

1999 acura tl wipers not working hear motor

if you hear the motor running but they are not moving first check the nuts on the bottom of the arms if they are tight remove them the the cowl panel and look at the linkage under the panel for the rods being off if there ok check the nut on the motor
0helpful
2answers
1helpful
1answer

Where is the location of acura tl 2004 wiper motor?

The wiper motor is located in the left rear of the engine compartment near the corner by the driver side. Remove the wiper arm assembly (both if necessary) and then remove the plastic cover at the edge of the hood near the windshield the motor is underneath. To remove the wiper arm flip up the small cover where the arm is attached and you will find a (12mm usually) nut. Remove the nut and work the arm off of the post using a rocking motion. Hope this helps.
0helpful
3answers

1999 ford explorer rear wiper don't work

hi there
this is pretty typicalof rear wipers check fuse first to make sure it is good if that doesnt work it is probably the motor which goes out and you can pick one up at your local auto parts store hope this will help you and have a great day
0helpful
1answer

What position do you put the wiper linkage in when you fasten it to the motor shaft?

tTHIS SHOULD BE DON IN >WIPER-PARK POSITION ONLY WIPER-PARK = OFF POSITION
0helpful
1answer

Windshield wipers stoped working i think it is a fuse. [email protected]

COULD BE FUSE.IF FUSE GOOD.CHECK TO SEE IF POWER GOING TO WIPER MOTOR.IF YES.REMOVE WIPER MOTOR HOT WIRE IT USING JUMPER WIRES TO CAR BATTERY.IF WIPER DONT WORK IF HOT WIRED.WIPER MOTOR IS BAD.IF WIPER MOTOR WORKS HOT WIRED.YOUR WIPER LINKAGES BINDING. NEED LUBRICATING OR REPAIRED.
2helpful
2answers

Windshield wipers don't work right. Try to and quit mid cycle.

YOUR WIPER MOTOR COULD HAVE BINDING LINKAGE AND PIVOTS.TRY LUBRICATE THEM WITH WD40.TRY NOT TO GET ANY ON WINDSHIELD.IF THIS DONT WORK WIPER MOTOR COULD BE FAULTY.
1helpful
2answers

Windshield motor make noise but the wiper don't move

Remove the wiper blades then remove the cover and you will find that the linkage has come off the motor.Replace the linkage or fit a new one.Hope that was helpfull.
Not finding what you are looking for?

916 views

Ask a Question

Usually answered in minutes!

Top Acura Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...