Driver side window won't go all the way up and makes a funny sound when going up and down.

this may sound funny but I have done this many times. go to your local junk yard and find a vehicle like yours and tear into it. you can see the inside of the door and how it all works. Sounds like the attaching mechanism from the motor to the window track has come loose. You may be able to buy the parts at the junk yard for cheap and fix it yourself. It has gotten me out of a lot of jambs and very cheap too.

take door panel off it has probably fell off runner

the passenger switch need to be replaced

It sounds like it could be the window solenoid, or the window motor. It's unlikely the switches on both doors are bad. Check the solenoids and motors...

make sure power windows lock out switch on driver side not on position, that will cause power windows not work or you have faulty power window relay.

If your window goes down...your motor is good...I had the same problem in my Pontiac Bonneville..It ended being a bad switch...I changed it..end of problem....I hope this was helpful.....PEACE....

You also have Circuit Breakers for your windows, Or your Master Switch ,You can Test the Driver Control Switch or the rear switches by removing the Switches and using the connector Plug and a Jump wire try jumping accross the wires,if they go up or down you could have a Bad Switch,if nothing moves more than likely your Window Motor is bad. BUT first CHECK your Circuit Breakers ,It could be Labeled as accessery Relay or circuit Breaker.

This sounds like a stuck switch,try to unplug the switch (drivers side window) first and it should cure your problem.Let me know if this does it,,if not i will help you solve this issue

does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.

If it does not make any noise, or sound like its getting any power, most likely its the switch.