SOURCE: expansion valve location
raven 1g: Your car doesn't use an expansion valve. It uses a fixed orifice tube which is located in the smaller of the two A/C lines, just before they enter the cabin area of the car.
Just disconnect the line and pull the orifice tube out of the line. Be careful not to break off anything and leave it in the line.
SOURCE: 2004 mazda MPv Where is the location of cyl. #6?
The firing order is 1-4-2-5-3-6. The cylinders are, front bank is from drivers side to passenger, 6-5-4 , and 3-2-1 at the firewall.
SOURCE: Drivers side window has slipped off track 2006 mazda mpv
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.
SOURCE: can't locate the pcv valve 2006 mazda 3
it located behind intake manifold, the intake manifold must be removed to get to valve, once you remove intake you will see pcv valve, dumb place for it i know,good luck.
SOURCE: 2004 Mazda MPV vacuum line from pcv valve and
You have the wrong type hose on the pcv valvle. It isn't vacuum hose.
Testimonial: "thank you you have been very helpful i understand now but the hose that is on the new pcv valve is a vacuum hose "
230 views
Usually answered in minutes!
×