SOURCE: headlights wont come on and bright lights won't stay on hold bright light switch and blower works
I had the same problem. The solution is simple; the ignition switch needs to be replaced. This is an easy do-it-yourself project. Here are instructions:
http://forums.vwvortex.com/zerothread?id=2532481
Check for a switch on ebay, they are about $15. After 10 years they wear out.
SOURCE: 2006 vw jetta tdi service engine light reset
With the key in the ignition (but not turned), press and hold the Odometer Reset Button on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument pane(if pressing doesnt work try turning the knob clockwise until service light has gone off and skip the pressing)l. Release both buttons at the same time.
SOURCE: red oil light flashing, oil change no problem but
Yes it is related, don't drive it. First thing you should do is install a new oil filter even if it isn't time for an oil change.
SOURCE: 2001 vw jetta gs :check engine light goes on and off
sounds like a faulty sensor tripping and reconnecting.. the next time the light comes on, take it to an advance auto store or an auto zone, they can read your codes for free... this will tell you what is being tripped, that way you know exactly what you need to get checked and/or fixed instead of a mechanic poking around trying to find everything thats NOT wrong. but if you are not expeiriencing any difficulty with the car, you should be fine. the check engine light actually means alot less than most people think. its usually a transmission or emissions sensor, or even as simple as leaving your gas cap off after filling and then driving for awhile.
SOURCE: how do i change a brake light bulb on 2000 vw
Removing:
Installing:
Rear Light Bulb Holder Removing And Installing:
Removing:
Installing:
And the Center Mounted Brake Lamp.
High mount Brake Light Removing And Installing:
The high mount brake light is installed in the rear shelf.
Removing:
NOTE: The bulb holder base plate contains soldered- in light emitting diodes (LEDs) that are not replaceable. In the event of LED malfunction, replace complete bulb holder.
Additional
212 views
Usually answered in minutes!
×