How fix broken grab handle

Look at the handle first. Did the handle break or the end of the cable. Usually handles break. Replace it. Until then, use a pair of pliers to pull the cable. Is the cable broke. Usually there is enough sticking out to grab with pliers. Replace the cable. If broken on the latch end. Take it to a garage that has done them.

OK, if the cable is the part that broke AND it broke at the handle, then you can use a pliers or vise grip to grab the end and pull on it to pop the hood, if it broke somewhere inside the cable, then you will need some needle nosed pliers to reach under the hood and grab it there. if it broke off at the hood latch itself, then you will need to get/ make a hook or pushing rod to engage the mechanism directly to release the latch and then replace the cable the latch looks like this:

i would think that this is the handles that are on the left and (or) right side of the windshield inside that car. if so there should be one or 2 oval inserts that cover the screws / bolts. carefully remove by GENTLY prying on the edge with a slow rocking motion. once removed simply remove the attaching hardware and reinstall handle ... there may be soon torque spec required if not available tighten fully and pull and twist the handle it should not move

door handle broke depends on what door handle it is.if door cant be open on out side out side door handle broke.if cant open door on inside inside door handle broke.door handle clip that connects to latch rod broken.when you try open door handle not engage to latch rod.door not going open.have to replace door handle with new clip holds latch rod in place.

Inside the car where you broke the handle off the hood release you will have to look under the handle or behind the dash to find the cable that it was attached to. IF you find the cable you can grab it with a pair of pliers and pull it to release the hood. It works just like bicycle brakes if you know what i'm saying. Very simple. You shouldn't have any issues finding it. THanks.

At the left floor the cable that releases the hood is behind the kick panel. The plastic handle that broke off can be accessed by removing the panel and you will see the last bit of the plastic handle that is threaded on the steel rod. I an emergency you can grab the rod with pliers and pull to release the hood (bonnet). Go to you local dealer and you can order a new handle or go to a wrecking yard and find your car model and just remove and purchase the used handle. You may be able to grab the rod that the handle broke off from with out removing the panel. Good luck.

If there is a bit of the broken end of cable still visible where it broke off from the handle, try grabbing it with a pair of vise grips to pull it and open the hood.
Maybe the handle will need to be removed in order to get to the broken end of the cable.

Usually the handle breaks off the cable, you should be able to use some vise grips to grab a hold of the cable and pull it to open the hood. To repair it the cable assembly will have to be replaced. If not you will have to gain access to the latch which is located in the front center of the hood and using a screw driver or something similar push the lever to release the latch.

Pull the door panel off. There is a clip that holds the bar to the handle on the inside. The clip often breaks. Worst case you can grab the handle from a salvage yard for about 20 bucks.

if the cable is not broken then pull the release then take the side of your fist and pound on the hood starting towards the top drivers side and slowly move towards the latch try it a few times i have to do this every single time on my blazer