I have a 96 Dodge Stratus. With 2.0 engine. Replaced water pump and now check engine light on pulling up code po1390 a timing code and it still bubbleing when i run it and losing water Did timing juup

i hope this helps for the water pump. The thermostat is located at top of engine simply follow upper hose to engine and remove housing and replace thermostat.

Dodge Chrysler - YouTube

? 2:54
https://www.youtube.com/watch?v=vs2DuvehVGA
Oct 31, 2013 - Uploaded by 1A Auto Parts
I want to know about a Dodge Stratus 2002 sensor. ... I have a 05 Chrysler 300 2.7 engine with a fault code ... images for Where is bank 1 sensor 2 located at on ...


More images for Where is bank 1 sensor 2 located at on 2003 dodge stratus with a 2.4 engine

Where is bank 1 sensor 2 located at on 2003 dodge stratus wit

www.fixya.com/cars/t26025690-bank_1_sensor_2_located_2003_dodge
22 mins ago - SOURCE: check engine light is on...bank 1 sensor1 oxygen sensor. if u have one .... 2.7L dodge stratus/ #1 bank #2 sensor location? on 2004 Stratus. Oct 24 ... How can I set the timing on a 1996 dodge stratus 2.4l engine.

P0137 02 Sensor Circuit Low Voltage - OBD-Codes.com

have you checked the leads or dispac. any cracks in leads or rubbers change. dispack you need to take this out and check for splits in the case. and water damage if any replace. also check the fuel line filter. and pressure valve on fuel line.

Your belt is out one notch on the oil pump which causes misfire

You have to count the number of flashes between delays. For example, the light flashes twice, pauses briefly, then flashes 4 times. This problem code is 24. The end of the trouble code is 55, which is 10 flashes so you have at least 2 trouble codes on your vehicle.

If it's like my wife's '97 stratus, the water pump is driven by the timing belt. That means you have to take a bunch of stuff off that side of the engine, including the engine mount to remove the timing components. How do I know this? A couple years ago, I replaced the timing belt and all associated pulleys and whatnot when the waterpump on that car failed. I did the whole job myself and did not have any leftover parts. Total cost on timing parts and water pump was about $250 at that time. I don't know what it would be now. Good luck to you.

sounds like plugged catalytic converter for the exhaust... have it ckd out

Is the water pump driven by your cambelt?If yes then probably misplaced the positions when you replaced the water pump.

vacuum leak with brake booster

check for vacuum leaks