Cars & Trucks Logo

Related Topics:

C
Cheryl Combs-Rockelman Posted on Apr 19, 2015

Yes, my 2004 Jeep GC Laradeo, 4.0 Liter, was idling too high, began misfiring, would overheat easily if not moving, poor mileage. We have the idle air control valve replaced and throttle cleaned.

Helps with the idling, problem. But now it has POOR acceleration, the RPMS jump and fall without any acceleration. Now notice a slight shake of the car. Took it to Auto Zone the meter gave a code of P1763. What could this be?

1 Answer

Kasey Tomlin

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 4 Answers
  • Posted on Apr 19, 2015
Kasey Tomlin
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that hasĀ over 10 points.

Joined: Apr 19, 2015
Answers
4
Questions
0
Helped
1398
Points
12

The overheat problem is the thermostat

Testimonial: "The overheating seems to have stopped with the idle under control. It's idling good, but have this RPM jumping and with no acceleration, if I try to pick the speed up with acceleration the RPM'S really jump.. Auto Zone ran their diagnostic thing on this trip and got the error code. I need some assistance, as this is my transportation to work."

  • Cheryl Combs-Rockelman
    Cheryl Combs-Rockelman Apr 19, 2015

    "The overheating seems to have stopped with the idle under control. It's idling good, but have this RPM jumping and with no acceleration, if I try to pick the speed up with acceleration the RPM'S really jump.. Auto Zone ran their diagnostic thing on this trip and got the error code. I need some assistance, as this is my transportation to work."

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

How do I adjust idle on 2009 Toyota Corolla 1.8 liter

There are no provisions for adjusting the idle . The computer through the use of the IAC valve - idle air control controls the idle . There is a base idle set at the factory an should not be changed or messed with . What idle problem are you having ? low or high Could be IAC valve or air passages plugged . High idle the throttle plate could be gummed up an sticking ! If you were to change the base idle you cause check engine light problems .
How To Fix Car That Idles Poorly
1helpful
1answer

Have a 2004 Murcury Sable. Whenever I turn on the heat the car starts surging high and low then shuts off. Doesn't overheat but idles poorly??? Only when turning on heat or air.

Problem With Idle Air Bypass Valve May Cause Engine ...

repairpal.com > Problems > Mercury > Sable
If you experience difficulty starting the engine when cold, stalling at idle, ... Also, this summer electric locks stopped working and recently car seems to idle high whensitting or when I put heat on. ... I was either braking and barely moving in traffic andwhen I would also turn on the ... 2004 Mercury Sable- 3.0L V699,000Visitor.

03 MERCURY SABLE ROUGH IDLE CAUSE - YouTube



0helpful
1answer

My ac is acting funky. my ac will blow cold air as im moving. once i stop and idle for longer than 3 or 4 minutes, something will kick on and then it will start to blow hot air. as this happens, my car...

Start by checking to make sure that the a/c condensor and radiator is not full off debris. If the condensor and radiator were full of debris it will limit the air flow from the engine cooling fan which in tern will cause a high discharge pressure on the discharge on the a/c causing poor or no cooling at idle and could also cause vehicle to overheat. Check and make sure that the cooling fan as well as the condensor fan are coming on together when the a/c is turned on if equipped with 2 fans.
1helpful
1answer

I have intermittant shuddering and it idles rough (rpms jump up and down) and noticed poor gas mileage, 106,000 miles and I just had the fuel filter changed, but that did not take care of it. It is firing...

P0303 is misfire number 3 cylinder P0316 is misfire on startup,Go to the number 3 cylinder at idle listen for a vacuum leak like a rupture or disconnected vacuum line more than likely that is your problem you have
0helpful
1answer

High idle on cold start on a 86 dodge d50 2.0 liter

0helpful
1answer

Wont idle right

Leaking fuel injectors? Hard to start, poor gas mileage, runs fine at high speed
1helpful
4answers

My jeep idles rough but on acceleration is powerful as can be.i have changed plugs wires cap rotor and have scanned it with only misfire codes

hola como puedo saber cual es el problema con mi 96 grancheerokie cada vez que acelero despues de 1500 rpm el motor pierde fuerza y avienta explociones por el throurolbody ya cambie los sparkplugs,cables, rotor, cap y el motor ya esta a tiempo [email protected]
3helpful
1answer

04 Jeep starts but stalls when put into gear.

make sure your idle air control motor is working, if you give and hold gas pedal a little will it stay running in drive.
7helpful
1answer

2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving.

I had the exact same problem on my 04 GC. I put some Techron Concentrate Plus Fuel System Cleaner in from Wal-Mart and it seemed to fix the problems right away. Let me know.
Not finding what you are looking for?

180 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...