Yes but you need another idler pulley.
Check to see if the AC belt turns anything else, like Power steering, Alternator, Fan, etc. I had a car with defunct AC once, and took its' belt off (the belt was just for AC) with no problems.
SOURCE: need diagram for serpentine belt on 2000 Ford Taurus, 3.0L
http://i28.photobucket.com/albums/c207/jwko/01TaurusBeltDiagram.jpg
Just go to this link and it is there.
SOURCE: Fan shroud removal
You need to take the fan off as well if you have a mechanical fan. IF you have the electric fan in the shroud, it comes out with the shroud.
SOURCE: need diagram for instaalling serpentine belt on
Picture is for the carbureted model but has the same patter as my fuel injected model. It's actually pretty easy to see how it goes. If the pully has groves then the grove side of the belt will fit right in it prefectly. If it's smooth then the back side of the belt with run along it. To loosen the belt tensioner do two things. first in the picture below you will see in the top middle you will see the tensioner. The back of the belt runs along it. You will notice that it looks like a solid peice. loosen the top slighty with i believe a 15mm. After that connect to the pully attached to it and pull back to the passenger side until you can slid the belt off the alternator. put back on in reverse order. really really simple once you do it. good luck
SOURCE: I need instructions and a diagram to bypass the ac
simple trick provided you can do this by running some twine around your pulleys allowing for1-2 inches less for slack adjuster an that will pretty close.or they may have for that system without ac meaning the condenser unit.
SOURCE: replacing serpentine belt on 2000 chevy van need belt diagram
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
I am assuming this "van" is a Chevy Venture?
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2000/make/chevrolet/model/venture/2000_chevrolet_venture_drive_belt_routing_diagram.htm
311 views
Usually answered in minutes!
×