SOURCE: headlight replacement 1998 GMC Sierra
there are two rods that slide down from the top. you have to turn to get them out of clip then pull up. once both are out then headlight can be removed.
SOURCE: 2003 GMC Sierra heater Blower wont shut off
My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.
SOURCE: Replace 2005 GMC Sierra Daytime Running Lights...
Open the hood, and in the top right and left corners of the primary headlamps you'll see two pins (L shaped) swing them out (towards the front of the truck) and lift out. This allows you to remove the upper headlamp assembly. You can then remove the lower assembly by pushing outwards on the plastic clip that is hooked into a metal clip. Once it's out you just turn the bulb to remove it.
It's much easier if you unhook the leads to the upper assembly's bulbes so you can set the whole thing aside.
SOURCE: I changed batteries in my 2003 GMC Sierra key fob
1. Close all doors
2. Insert key into ignition
3. Hold down the power UNLOCK button on the driver's door panel, continue to hold down
until instructed to release in step 9.
4. Perform steps 5 through 8 in a fairly rapid succession.
5. Turn the ignition to the ON position (as far as you can go without starting the engine.)
6. Turn the ignition to the OFF position.
7. Turn the ignition to the ON position (as far as you can go without starting the engine.)
8. Turn the ignition to the OFF position.
9. Release the power UNLOCK button on the door panel. The vehicle should respond by
door locks locking and unlocking automatically. (If locks do not cycle after you let go,
not before you let go of the unlock button, then the vehicle has not entered programming
mode and you must start procedure over. Remove key from ignition, open drivers door
and return to step 1 ). If the locks do cycle automatically then proceed to step 10.
10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock and
unlock. This may take up to 30 seconds.
11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).
12. Turn the ignition to the ON position to exit the programming mode.
13. Test remote(s).
SOURCE: wiring diagram 2003 GmC Sierra
I need wiring digram for GMC 2003 SIERRA . I have the left head light working fine but the right I have no power to it. I have checked the fuses and relaysand so far have not found and broken or frayed wires.
157 views
Usually answered in minutes!
Hi william colley, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?
×