Wiper relay for 2000 s40

Did you check the wiper relay's in the under hood fuse box ? There are two ,wiper run/park relay & wiper high low relay ! Also ,did you check fuse's ? fuse # 11 - 30amp location cental juction box . The wiper switch is a input to the GEM module . Generic electronic module . The module in most cases isn't the problem ! Learning how to test these electronic systems is , people do not know how to test so they just replace parts . What they should do is take the vehicle to ford certified Technician who has the knowledge and testing equipment to find an fix it .

The generic electronic module (GEM) receives inputs from the following:

• multifunction switch
• anti-lock brake control module (vehicle speed signal [VSS])
• ignition switch

The GEM uses these inputs to control the outputs to the following:

• windshield wiper high/low relay
• windshield wiper run/park relay
• windshield washer relay
• rear wiper motor relay
• rear window washer relay
• 
  GEM Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1240 Wiper Washer Rear Pump Relay Circuit Failure GEM GO to Pinpoint Test K . B1241 Wiper Washer Rear Pump Relay Circuit Short to Battery + GEM GO to Pinpoint Test K . B1342 ECU is Defective GEM CLEAR the DTCs. REPEAT the GEM self-test. If DTC B1342 is retrieved, INSTALL a new GEM. REFER to Section 419-10 . B1431 Wiper Brake/Run Relay Circuit Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
  If the windshield wipers stay on continuously, GO to Pinpoint Test C . B1432 Wiper Brake/Run Relay Circuit Short to Battery GEM GO to Pinpoint Test B . B1434 Wiper Hi/Low Speed Relay Coil Circuit Failure GEM GO to Pinpoint Test D . B1436 Wiper Hi/Low Speed Relay Coil Circuit Short to Battery GEM GO to Pinpoint Test D . B1438 Wiper Mode Select Switch Circuit Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
  If both the windshield and rear window wipers are inoperative, GO to Pinpoint Test L . B1441 Wiper Mode Select Switch Circuit Short to Ground GEM GO to Pinpoint Test C . B1446 Wiper Park Sense Circuit Failure GEM If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E .
  If the speed dependent interval mode does not operate correctly, GO to Pinpoint Test G .
  If both windshield and rear wipers are inoperative, GO to Pinpoint Test L . B1450 Wiper Wash/Delay Switch Circuit Failure GEM If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E .
  If the wash and wipe function does not operate correctly, GO to Pinpoint Test F .
  If both the windshield and rear wipers are inoperative, GO to Pinpoint Test L . B1453 Wiper Wash/Delay Switch Circuit Short to Ground GEM If the windshield wipers stay on continuously, GO to Pinpoint Test C .
  If the wash and wipe function does not operate correctly, GO to Pinpoint Test F . B1458 Wiper Washer Pump Motor Relay Circuit Failure GEM GO to Pinpoint Test F . B1460 Wiper Washer Pump Motor Relay Coil Circuit Short to Battery GEM GO to Pinpoint Test F . B1473 Wiper Low Speed Circuit Motor Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
  If the windshield wipers do not operate at high or low speed correctly, GO to Pinpoint Test D .
  If the intermittent windshield wiper speed does not operate correctly, GO to Pinpoint Test E . B1475 Accessory Delay Relay Contact Short to Battery GEM REFER to Section 501-11 . B1476 Wiper High Speed Circuit Motor Failure GEM If the windshield wipers are inoperative, GO to Pinpoint Test B .
  If the windshield wipers do not operate at high or low speed correctly, GO to Pinpoint Test D .
  If the intermittent windshield wiper does not operate correctly, GO to Pinpoint Test E . B1611 Rear Wiper Mode Switch Circuit Failure GEM GO to Pinpoint Test H . B1614 Rear Wiper Mode Switch Circuit Short to Ground GEM GO to Pinpoint Test I . B1820 Rear Wiper Motor Up Relay Circuit Short to Battery + GEM GO to Pinpoint Test H . B1839 Rear Wiper Motor Circuit Failure GEM GO to Pinpoint Test H . - All other DTCs. GEM REFER to Section 419-10

you have to replace wiper switch. wiper control relay is in the switch

The problem would be in the stalk controller. The wiper Relay is what provides power to the motor for all settings, the delayed wipers, low speed, and high speed. There are not 3 relays, but 1 for all functions. If you have power to the high setting, the relay is working.

03 Ascender but what is and Intrigue? (apples and oranges, diffr)
built at:
GM Fairfax plant in Kansas City, Kansas,
2000 Oldsmobile Intrigue in wrong forum, my guess.
why not post the symptoms first. dead on all speeds, and does
it have the intermittent option?
why assume there is a relay?
would not the fuse be first.? if dead?

wiper not washer is FUSE WPR 25amps.
does the wiper work on WASH mode, 1 swipe. (trick 1)
does the wiper run on any speed? (sop)
no and no.the fuse is blown
to test fuse, use a voltmeter.
Keyon
12vdc on both sides of WPR fuse, is a good fuse. no lies, no guessing. fuses that look blow are blown but some that look ok
are in fact blown (due to hairline cracks only mini mouse can see)

there IS NO RELAY. soRRY, i can add one if you like (LOL)

here it is.

could be either but i would go for the relay first

replace the motor.it will stop being goofy after that i promise

i belive that your wiper switch has gone out on the intermittent side. this is a very common problem.
I hope this helps you
Thanks
Please leave rating

try replacing the wiper relay

or could be a faulty wiper intermittent part of the switch

Behind Headlamp remove wiring clip and tape it off. At the same time tie off the water pipe. That'll do the job quickly. Otherwise removing the whole wiper system isn't a big job.

possibly a relay the one for intermittent wipers is #16 front under dash relay panel