How do i get the hood open on my 2000 Land rover Discovery II. The hood latch release cable snapped at the hood latch.

Hi welcome main problems are the abs valves causing the 3 dash lights (search 3 amigos online) a really badly sited compressor can cause air suspension models to fail giving the bags a slow leak the V8 is a solid engine but can have radiator expansion tank and cap failures
the other issue is electrics windows and door looms are problematic

The way this is done is to use a good lamp to see through the grille...the latch..and then, using a long , strong tool / rod - this is used to unlatch the lock latch and the bonnet will lift...latching / locating your tool on the part of the lock that the cable attaches to.

I hope this helps :)

Follow the old one 'out' with the new one 'in'.

You can adjust release on front brace by loosening bolts and setting it. I grease all my latches with moly grease. And lube cable under dash shield.

Please check the a/c compressor clutch; it may be not working. FYI the compressor does not run all the time. It is the clutch that will cycle on and off to maintain a/c circuit pressure. To check, put the a/c on high and watch the compressor under the hood to see if it cycles.

Pull the bonnet release. On RHD vehicles the release is in the LH footwell on the side under the glove compartment. I think that on LHD vehicles it's still on the LH side.

The code P1451 on a Land Rover is "Leakage Detection Module Motor power stage error Drive cycle A:Signal out of range - above maximum". This is an OBD-II diagnostic system code. As far as I know, a 1995 Land Rover Discovery does not use a OBD-II system. Is it possible that this rover is a later model year

take them out and clean the gears and track should work fine.

http://carservicemanuals.blogspot.com/2008/06/range-rover-discovery-ii-defender.html

GL

LAND ROVER DISCOVERY II DONT HAVE FUEL FILTER, ONLY HAVE PRE FILTER IN THE FUEL PUMP