Rear wiper motor how to remove it

SOURCE: rear wiper motor

raise up the tail gate . remove the phillip screws holding the handle or pull down strap.remove all other screws holding the rear plastic tail gate panel in place than start in one corner try to pull down on the plastic panel as it is also held in place with push style plastic clips.you can use a straight blade screw driver to start releaseing the clips.once you have the panel off you have done the hard part/ just unbolt the wiper motor and reassemble.
good luck chris

SOURCE: 1990 dodge ram pickup wiper stopped working. Motor

First you have to remove the metal caps covering the wiper blade locking nut then remove the nut and leftthe wiper arm assembly up and rock back and forth till loose. then pull arm off as you wiggle the arm. next raise the hood and remove the 4 inside screws at the back of the hood remove the valance and the 2 plastic holding clamps then lift up. Once you have valance off look to see if the gears are stripped on the motor or the shaft if they are go to a junk yard and buy new parts. you will find the short rod and a long rod, they should be connected, if not the ball on the end of the long rod may have poped out turn on key then wiper motor and watch the parts move. You will be able to see it right away.
Hope this helps. If you need more asstance please post here and thanks for using fix-ya
Avid101