No sir, on the ly7 HFV6 3.6l in the 04-09 srx and cts the knock sensors are located on the sides of the engine block. Bank 1 and two are visible fringe wheel well. Not to hard to get to with a 3/8 drive 13mm socket, universal joint, and short extension. I would also check the connector with a multi meter while doing this job to ensure you have a good connection and harness is not damaged. Best of luck!
SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
SOURCE: Changing fuel filter on 2004 Cadillac SRX
If you go to the auto parts store they should have a fuel line disconnect tool that has a 5/16ths end an a 3/8ths end. The tool is shaped like an X. Before you start you need to pull the fuel pump fuse under the front of the REAR passenger side seat while the car is running and let it stall. it will release the built up pressure. This is important unless you want gas to spray every where. Then take the tool and start with the end of the filter with two lines. Place the appropriate end of the tool over the smallest inlet, push the tool in then pull the line towards the filter and then push the line away and it should disconnect. Do the same with line above. Then you can use the two appropriate size wrenches to disconnect the outlet end. reconnecting the new filter is simple just make sure your quick connect lines click in all the way and you tighten the outlet line well, I think its like 22 or 25 ft/lbs.
SOURCE: where is cylinder #1 on a Cadillac V6 engine 3.6
Right bank is 1,3,5.and left bank is 2,4,6.Hope this helps.Good luck.
SOURCE: where is knock sensor located on 2004 chevy 2500Hd
Under intake manifold on top of block,you need to remove intake to access sensors there are two of them you can't miss them when intake is off. After replacing sensors you need a new intake gasket.
SOURCE: where is the knock sensor located
The knock sensor is located under the intake manifold.The starter is also located under the intake manifold.Hope this helps.Good luck.
Testimonial: "it was helpful informations,appreciate that."
1,376 views
Usually answered in minutes!
×