SOURCE: 1999 323i BMW
I finally fixed this problem! Not sure if it will work for everyone but it did for me. My new mechanic said there is an electronic 10 pin connector hooked up to the throttle body and mine had 2-3 pins that weren't making a good connection....THAT'S IT!
SOURCE: How to reset brake light after changing pads.
once you have replaced the brake pads and a new sensor , turn on the ignition without starting the engine for approx 45 seconds and the warning light will reset itself , regards mark
SOURCE: I had the battery in
ive had the same problem on my 1998 Bmw 323i when i took my battery cable off what you have to do is leave your key in the ignition position 1 so the radio is on and says code wait. you have to leave the key in the ignition in that position for about 30- 1 hour long then it should reset back to where you enter your radio code. you only have about 3 trys to get the code right then it will say code wait again. you need to find out what your radio code is. my radio code was 46661 but we could have different radios. you can either bring your car to the dealer or just take out your radio and get the serieal number off of it which is what i did and i typed bmw radio code in online hope this helps !!
113 views
Usually answered in minutes!
×