Https://www.fiatusa.com/download/pdf/manuals/2014-FIAT-500L-OM-1st.pdf
it's in your owners manual page 358 chapter 7
you need a torx 20 screwdriver or bit
Rear Tail, Stop, Backup And Turn Signal Lamps
1. Open the liftgate.
2. Remove the two screws and remove the tail lamp assembly.
3. Remove the four screws (using a T20 driver) and separate the backplate from the lamp housing.
4. Remove the tail, stop, or turn signal bulbs by pushing them slightly and turning counter-clockwise.
5. Remove the backup lamp bulb by pulling straight out.
6. Replace lamps as required and reinstall lamp.
Center High-Mounted Stop Lamp (CHMSL)
This light is an LED assembly. See your authorized stealership
SOURCE: I have a 2014 kia carens with brake light problems. Can u advise location and access to the switch
Brake light switch is located on the brake pedal lever, up high close to the firewall.Check the leads with a test light, it should be hot all of the time, even with the key off.
2,767 views
Usually answered in minutes!
×