1993 Chrysler Town & Country Logo

Related Topics:

Posted on Mar 27, 2015

Has anyone lost the information on their 91-93 Town & Country digital instrument panel? Does anyone know what the blinking * on the IP?

My daughter called to say the T&C wouldn't start. When I got there the battery was down on it. I jump started it, while I was charging it, I could see the digital dash was working, when I finally got the van started, the digital dash lights up, but there is no information on it. The gauges, tach, speedo, odometer don't display anything, it lights up, and when the key is first on it shows all the segments on. There is a * that blinks on and off right by the word TRIP, I haven't seen it before, and I am guessing it means no data. I also found that the rear lift gate won't release, the interior lights don't come on when the doors are opened, though they come on when individually turned on, and the wipers work on low and high, but not intermittent. When I shut it off, the fasten seat belt light goes on and off and it I turn the instrument panel dimmer up or down it will blink faster or stop. Anyone else run across anything like this?

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Jul 14, 2009

SOURCE: 2006 Town and Country, While driving the warning

I had the same problem and it happen to be my battery. 05 Town and country lx.

Ad

Anonymous

  • 3 Answers
  • Posted on Sep 18, 2009

SOURCE: Instrument Panel Problem - Electrical

check all wiring and maby youl get it right

co7196

Ned C Cook

  • 3433 Answers
  • Posted on Oct 19, 2009

SOURCE: dash lights are staying on/van cuts off after start

Vheck for a dashboard groung wire. It should be aon the passenger end screwew to the dash frame and the body ofthe vehicle. AND! There is a ground strap from the engine to the body. It is on a bolt on the top of the engine in a spot the engine is nearest to the body. Make sure all grounds are cleN AND SECURE, GOOD LUCK,_NED_

Anonymous

  • 277 Answers
  • Posted on Nov 28, 2010

SOURCE: turned key..nothing happened, dead, no dash lights

Check ALL Power and Ground connections coming off the Battery to circuit anchor points. Ignition and Services fuses for a Power supply. If all proves ok, then go to the Main Ignition control Relay and check the condition of the Pins and Recepticles. That is where your apparent problem may eventually be. But travel the initial route first, looking and feeling for Loose or Dirty connecting points.
Regards, David

Anonymous

  • 747 Answers
  • Posted on Jul 07, 2012

SOURCE: Town and country 2005 key fob will not unlock front doors. It will however open the tailgate??

do you have a second fob try it battery may be low may need reprogramed or replaced check with your dealer

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer
0helpful
1answer

I need to know how to install an after market radio in a 1997 town and country lx

Go to Best Buy Or Pap Boys and Buy an Aftermarket install kit and A direct fit harness! Very easy to remove center bezal:
  1. Remove screw access cover.
  2. Remove the attaching screws holding bottom of the bezel to instrument panel.
  3. Remove the attaching screws holding top of the bezel to the instrument panel.
  4. Remove the bezel from the instrument panel.
  5. Disconnect the wire connector from back of the rear blower switch, if equipped.
  6. Disconnect the wire connector from the back of the HVAC Control.
  7. Remove the bezel.
0helpful
1answer

Computer failure on instrument panel and fuel injection.

check the fuses first, take agood look at the instrument panel fuse, the cluster will blink and van will no run or sometimes start and stall,i would start there.
2helpful
1answer

My 6 disc DVD changer will not eject, nor play. The lights blink back and forth from the 3 left lights to the 3 right lights, whether the van is on or off. I disconnected the battery to reset it, but to no...

I'm having the same problem, although I didn't get the 3 left 3 right thing until I reinstalled the dvd changer to see if it worked. The Haynes manual for Chrysler Voyager & Town & Country 2003-2006 has the steps you'll need to remove it. Just refer to page 11-18, 11-19 for removing the instrument panel, then page 12-9 for 'radio' removal. If you can't get the manual let me know.
15helpful
1answer

Codes - U0140, U0155, U110C

2005 town and country code U110C this problem?
0helpful
1answer

Electrical blinks off momentarily

Check all your electrical conections and the one on the back of your alternator. hope this helps you out Phil
1helpful
1answer

Unknown engine codes

The message you are getting are not V's but U's, they sometimes are hard to read what the letter is but here is your answers:

U0155 Lost Communication With Instrument Panel Cluster (IPC) Control Module

U1100 Invalid or Missing Data for Primary Id
U110C No Fuel Level Bus Message

U0140 Lost Communication With Body Control Module
Not finding what you are looking for?

57 views

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...