Need to program
SOURCE: key fob will not lock or unlock doors on 06 Sonata
Hi there
i have the same problem but mine is the sensor that is under the dash that is faulty so i had them disable it untill i can get a part that they need to order so i would have your dealer check the sensor .. if it is under warranty they will replace it for free
SOURCE: programming key fob on 2006 sonata
Couple of times when you replace the remote battery, you might
have them not working/ responding but just follow the procedure below.
Stand
close to the car, hold down the open and close knobs for about 10
seconds. Press them at the same time for 3 seconds; then press the open
button as the car opens.
The above procedure is applicable to a lot of car brands. It does not matter how many knobs you might have on the remote fob.
I have carried this procedure out on a lot of brands ranging from Honda, Toyota, Rover, Ford, etc. and it works perfectly well.
Good luck and Rate this.
Cheers
SOURCE: need to program key fob for santa fe 2011
you have to take it to the dealer and get it programmed with there computer. there is no other way to do so. sorry
SOURCE: how to program key fob for 2011 hyundai santa fe
Nonsense. I just programmed a new remote start fob on my 2011 Santa Fee limited and it worked just great. Follow the steps below and see what happens.
1. Open the drivers side door
2. Turn the Vehicle ignition to the ON position (Do not start the vehicle)
3. Locate the disarm/program button. (look closely, it is located on the wiring harness just inside the lower dash. it could be located just inside the fuse cover.)
4. Press and hold the disarm/programming button for 10 to 15 sewconds, the horm will beep 3 times. Release the disarm/programming button.
5. On the fob, press the Find/Panic button One time and the horn will beep one time.
6. Turn off vehicle ignition. (YOUR DONE)
128 views
Usually answered in minutes!
I had mine done at my local locksmith for around $90. Works great.
×