2001 Pontiac Bonneville Logo

Related Topics:

Posted on Mar 26, 2015

How di I remove the fuel tank on my 2001 Pontiac Bonneville?

Is the exhaust and rear control arm in the way?

5 Related Answers

Anonymous

  • 840 Answers
  • Posted on Jan 25, 2009

SOURCE: Can't figure how to romove right rear door panel on 2001 Pontiac

rt rear door panel should be easy their may be screws in and around the trim panel check for little top covers take off and screws are underneath them. know when you pull the trim off its mounted by retainers so be careful pull at bottom and work your way to the top pull upward and then take off you should be able to see after that

Ad
countrysi248

Jerry Koski

  • 443 Answers
  • Posted on Jan 25, 2009

SOURCE: Can't figure how to remove right rear door panel on 2001 Pontiac

These are bad about those Cable operated window devices .. If it is bad get on ebay and get one ordered its your best bet.. Just take a flat screwdriver and go around the bottom of the door panel and pop it loose and up the sides .. there might be a hidden screw or two in the middle around the handles.. good luck ..

Anonymous

  • 15 Answers
  • Posted on Dec 14, 2009

SOURCE: Control arms for 2001 pontiac bonneville ssei

No dont try a salvage yard! www.rockauto.com GREAT prices and SUPER FAST SHIPPING. they have warehouses all over the country! Control Arm for 01 Bonneville $78.79/each includes ball joint and bushings.

Anonymous

  • 2317 Answers
  • Posted on May 02, 2010

SOURCE: where is the rear control arm on the 2001 pontiac

I would say no. The rear control arm is bolted to the frame in the rear wheel area. It is rather involved to remove the control arm, and replacing the bushing involves using a press to press them out and install them.

Testimonial: "Your answer is tells me all that I needed to know to get this bothersome problem repaired. I will have to take it to the shop. Thank you!!!"

hepcars

Howard Pfeiffer

  • 1249 Answers
  • Posted on Dec 24, 2010

SOURCE: where do you start to remove rear door panel on a

You should first look at the underside of the arm rest...this needs to be removed before the panel...usually 2 phillips head screws...then gently pry the panel on the bottom...GM uses several push in plastic clips to hold the door panels in place...if yuou damage any of these...they are available at most parts stores in the "help section"...Hope this works for you:)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Where to locate the fuel filter on my 1991 pontiac bonneville

Make the FixYa experience better for everyone by voting.

Hi,

My name is Ben and I'm your guru, i.e., mentor, an influential teacher or popular expert: a management guru. - origin from Sanskrit, 'weighty, grave', for today.

Your fuel filter is located under the chassis, on the passenger side, beneath the rear door.

Be sure to remove the pressure before disconnecting.

All the best,

Ben
0helpful
1answer

Where do you start to remove rear door panel on a 2001 pontiac bonneville?

You should first look at the underside of the arm rest...this needs to be removed before the panel...usually 2 phillips head screws...then gently pry the panel on the bottom...GM uses several push in plastic clips to hold the door panels in place...if yuou damage any of these...they are available at most parts stores in the "help section"...Hope this works for you:)
1helpful
1answer

Where is the rear control arm on the 2001 pontiac bonneville and can a layman replace the busing in it?

I would say no. The rear control arm is bolted to the frame in the rear wheel area. It is rather involved to remove the control arm, and replacing the bushing involves using a press to press them out and install them.
0helpful
1answer

2001 pontiac bonneville codes 1351 and 1371

1351--IC circuit high voltage (ignition coil control circuit)

1371--DI low resolution circuit/Too few ignition reference pulses
2helpful
2answers

How do you replace the fuel pump on a 2001 camaro

Camaro, Firebird, 1999 - 2002 Repair Guide
Fuel Pump - Removal & Installation

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Clean the area surrounding the sender assembly to prevent contamination of the fuel system.
  5. Remove or disconnect the following:
    Fuel tank Fuel sender-to-fuel tank retaining ring Fuel sender from the fuel tank Fuel pump from the sending unit

    46aa2e5.jpg
    Fig. Fuel sender/pump assembly component identification
To install:
  1. Install or connect the following:
    NOTE The fuel pump strainer must be in a horizontal position and must not block the float arm travel.
    Fuel pump with new strainer onto the sending unit New O-ring in the tank opening groove New O-ring on the fuel sender feed tube
  2. Fold the strainer over itself and slowly position the sending assembly in the tank so the strainer is not damaged or trapped by the sump walls.
    Retaining ring Fuel tank. Torque the bolts to 33 ft. lbs. (45 Nm). Fuel filler cap Negative battery cable
  3. Turn the ignition switch to the ON position for 2 seconds, OFF for 10 seconds, then back to the ON position. Check for fuel leaks.

Hope this help (remember rated and comment this), good luck.
1helpful
1answer

How to replace fuel tank sensor on 2001 bonneyvlle

On my 2001 Bonneville there is access to the fuel pump and fuel tank level sensor from the trunk. Remove everything from the trunk as well as the carpet that covers the spare tire. You will see an aluminum looking cover near the back seat of the passenger side. Remove the five screws from the cover. I then had to use a screwdriver to lightly pry the cover off in a couple of different areas of the cover. It was pretty well sealed. Autozone's website has a fair step by step procedure as well.

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?fromSearchPage=true&pageId=0996b43f8036ee5e&partName=Fuel+Pump&partId=0996b43f8036ee5e

361b8b9.jpgcb95277.jpg
0helpful
1answer

Where is the gas filter on a 1998 pontiac bonneville

The fuel filter is located under car near gas tank, on the driver side follow the fuel line and it will lead you stright to it. I hope this fixes your problem
0helpful
2answers

Control arms for 2001 pontiac bonneville ssei

Try the Salvage yard, you can get then around $45.00 each if you pull the parts your self. Call around though, different Salvage Yards have different price and will always try to beat the price of another Salvage yard. They pull parts for you too if you don't fell like getting your hands dirty twice. Good luck.
4helpful
1answer

Trying to figure out how to remove the fuel tank from a 2003 Pontiac Sunfire... Have the straps, fuel line, and wires disconnected... it's still hanging there. Help.

YOU NEED TO DISCONNECT THE EXHAUST RUBBER HANGERS AND ALLOW THE REAR OF THE EXHAUST SYSTEM REST ON THE REAR AXLE.REMOVE THE FUEL TANK HEAT SHIELD.REMOVE FUEL TANK FILLER HOSE AT THE TANK.LOOSEN HOSE CLAMPS.SPRAY A LITTLE WD40 WHERE FILLER HOSE GO TO FUEL TANK.THIS WILL MAKE IT EASY TO GET HOSE OFF.USE LARGE CHANNEL LOCK PLIERS CAREFULLY.WORK HOSE OFF FUEL TANK.BECAREFUL DONT MAKE NO SPARKS.WORKING WITH FUEL TANKS IS LIKE WORKING WITH A TIME BOMB.BECAREFUL GOODLUCK.
0helpful
2answers

How to take off a gas tank on a 2001 Pontiac Bonneville. If have Manuel please send

disco nnect the battery, ground side first then positive. if there is a shield on the exhaust next to tank, remove that. on the back side of the tank you will see the 2 main hoses where the gas goes in, use a 8 mm to remove the 2 clamps out of the way. pry the 2 hoses off the tank. remove the 2 straps that hold the tank, 13 or 15mm bolts. only 2 of them. make sure the tank is supported before moving the straps. slowly lower the tank just enough to see the top of the tank. remove the 2 wire connectors. then disconnect the 3 plastic hoses. careful not to break them. squeeze the tabs and pull the off. don't need a lot of force. once off, then lower the tank rest of the way. may have to lower one side first to clear the rear axle. that should be it, step by step. take your time if your not use a real lift. will be a pain in the ****. best of luck.

Not finding what you are looking for?

368 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...