P1491 blocked EGR valve. P0705 transmission range sensor circuit (prndl input)
What is this P0705 transmission range sensor circuit (prndl input) and does it mean my transmission going bad or out?
no transmission not going bad. the code means something wrong with the sensor that tells the transmission what gear you selected external from transmission
oh ok thank you so much you were so helpful
×
SOURCE: 2000 Lincoln Navigator with rough idling and service engine light
i had the same trouble, there is a rubber boot under the cover on the top of the motor, it is coming from the egr valve, takes about 5 mins to repair and less than 5 dollars.
SOURCE: ROugh idle
there are 2 things that usually cause this, one is a dirty intake idle control valve and the other is hard engine mounts, I would say that both most likely apply to your car. try cleaning the intake with the following procedure from Ford.
Here is the most common cause of surges and stalls and low idle rough idle, it is the idle speed control air-bypass valve and throttle valve (IAC for short), they get full of gunk over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.
SOURCE: 2002 Honda Accord V6 check engine light on- local
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
255 views
Usually answered in minutes!
×