I have a 99 lexus es300 and the battery died lastnight because my girl friend left the inside light on. I gave it a boost this morning and the car is on and running but the dash is showing the abs light on and the o/d off sign? And ideas why this could be or what I should do?
SOURCE: 2000 Lexus ES300 - 45K
Are you sure this is a rattle or is it more of a creaking noise? I have a 2000 ES300 and had an issue when I would go over speed bumps and the noise would drive me nuts! However replacing the bushing in the top of the strut mount is expensive due to the labor involved.. Replacement of the strut or the bushing isn't necessary. Just open the hood, locate the strut housing and you ll be able to see the black rubber bushing in the middle. Obtain a can of Heavy Duty silicone aerosol spray and attach a straw to the spray tip. Using a flathead screwdriver wedge the screwdriver between the top of the bushing and the metal pushing the screwdriver all the way to the edge of the metal underneath the roof of the metal housing. Then pry the edge of the bushing away from the metal housing so that the top of the edge of the bushing exposed and stick the straw end of the silicone into the spot and spray generously. Only slight bushing movement will be obtained as the bushing is pretty stiff but it will be enough. Work your way around using this technique until you get the spray fully around the bushing 360 degrees getting it into the area between the edge of the bushing and the metal. Then spray the silicone onto the top of the bushing filling it all the way up until it spills over the metal. After it drains down, repeat again making sure you fill it above the rim of the bushing so it seeps into the area between the bushing and he metal housing (or frame) because this is where the rubbing is taking place that is creating that awful noise. Repeat on the other side and your done. The main goal is to get the silicone into the area between the metal and the bushing along the edge. This happens to be the way I was able to do it. This totally solved my problem and now the car is so quiet there aren't any knocking, creaking or rattling noises. This was a hard solution to explain without visuals, hope you can follow. This will work for sure. The Heavy Duty Silicone spray I used was manufactured by CRC and I bought it from Walmart.
SOURCE: lexus gs300 dash lights ,sunroof,gear lever,windows, not working
hello freddy - the good news is that your lexus has a self diagnosis system built into it. this is what you need to do.
drive to an auto zone or similar autoparts store and have them put your lexus on their computer to scan for trouble codes. they offer this as a free service. with a little luck this scan will isolate the problem and the fix will be quick and easy.
if this doesnt fix it for you get back and let me know what codes popped up.
here is a link to the lexus trouble codes so you will have added insight. good luck.
http://www.troublecodes.net/Lexus/
SOURCE: My 1996 lexus ES300 dash board lights are all out.
This will sound crazy but it has solved the problem more times than you would believe: give the dash board a and area around it a good wack with your fist. Often the connection to the light is what starts to fail not the bulb.
SOURCE: LEXUS es300 oil light stays on oil level full
Check oil level sensor, replace if necessary. also, does your engine knock or make a tapping sound?
114 views
Usually answered in minutes!
×