Where is AC compressor relay located on 2007 Dodge Ram 1500

SOURCE: check engine light on code

This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.

SOURCE: Reverse light switch on 1995 Dodge Ram 1500

switch is just above trans pan and below shift linkage requires a thin (crome 1" socket) to remove

SOURCE: bypass ac compressor 2006 dodge ram 3500 5.9 L

Hi:
The easiest method to do this is to go to an auto parts store and buy a belt designed for a truck with no air conditioning. The belt will be the right size, and you just install it as normal, and bypass the compressor

Testimonial: "a"

SOURCE: 2007 Ram Truck: where is low side of ac to recharge in 2007 dodge ...

The Low Pressure Side connector will be smaller than the High Pressure Side connector so the refill hose will fit properly only on the Low Pressure Side.
Read more: How to Recharge Air Conditioning with Freon in a Dodge Ram | eHow.com http://www.ehow.com/how_4484569_recharge-air-conditioning-freon-dodge.html#ixzz0uLXJnwvE

SOURCE: A/c compresor quit blowing in

2006 Dodge Ram 2500 Diesel 5.9 Cummins

There is no relay. The pressure sensor sends signal to PCM, then the PCM sends signal to the TIPM or total integrated power module which is sort of self contained fuse box but really a micro computer that controls many things. The Module has had known issues that can affect one of many things. I lean to bad module. Here is the diagram for compressor.

The Integrated Power Module (IPM) is a combination of the Power Distribution Center (PDC) (1) and the Front Control Module (FCM) (2). The PDC mates directly with the FCM to form the IPM. The PDC is a printed circuit board based module that contains fuses and relays, while the FCM contains the electronics controlling the IPM and other functions. The IPM is located in the engine compartment, next to the battery and connects directly to the battery positive via a stud located on top of the unit. The ground connection is via electrical connectors. The IPM provides the primary means of voltage distribution and protection for the entire vehicle.
The molded plastic IPM housing includes a base and cover. The IPM cover is easily opened or removed for service access by unscrewing the cover retaining nut and has a fuse and relay layout map integral to the inside surface of the cover. This IPM housing base and cover are secured in place via bolts to the left front fender support assembly.
Replaceable components of the IPM assembly are broken down into the following components:

• The Power Distribution Center (PDC)
• The IPM cover
• The Front Control Module (FCM)
• Complete IPM assembly that includes all three parts