All other gears work fine
Will the selector lever in the cab click into Park, or does the selector lever not reach that position any longer?
If it physically cannot reach the position and lock into it as per usual, then the linkage underneath needs adjustment.
if it reaches and clicks into Park position but the transmission does not lock, then there is a problem with the pawl not tngaging and locking the trans.
Always try to adjust the linkage before delving into the trans in cars something is worn, broken or has slipped put of position.
SOURCE: 1994 nissan altima gear shift lockout problem
replace the brake pedal switch, it is mounted in front of the brke pedal, this is what makes the silanoid work, if it is not working the silanoid will not.
SOURCE: just need to know the towing capacity for a 1994 nissan pathfinde
The towing capacity is 6000 pounds.
SOURCE: 2001 Nissan pathfinder is stuck in park
HEY! It is as simple as a blown fuse. In the fusebox on the lower left side of the driver's seat pull off the cover to the storage box and behind is the fuse box. The storage box reverse side has the labeling for the fuse location. Get yourself a fuse tester or just guess:) and use one of the spare fuses stored in the fuse box area. My problem was the exact same and it was a blown fuse for the "STOP LIGHT" which is the brake/taillights. Towing a boat I managed to get the lights on the trailer wet and shorted them out. Viola! Changed the fuse and it not only started but I could actually shift. Has been fine ever since. I now keep a set of varied fuses of the correct mini size in my glove compartment. Good Luck and I hope this helps.--Linda
SOURCE: 1996 nissan pathfinder driver side window won't go up and down
does it click or grind when pushing window button if so the window lift track may need replaced, if there are no sounds then disconnect the wires from the lift motor and with the ignition on so power is sent to switch, push button and check wires to 12 volts dc. If no power I would replace the driver side switch after checking the wires for defects. If there is power then I would re-install wires to motor after turning off key and try button again with power on. replace motor if it doesn't work.
Will the selector lever in the cab click into Park, or does the selector lever not reach that position any longer?
If it physically cannot reach the position and lock into it as per usual, then the linkage underneath needs adjustment.
if it reaches and clicks into Park position but the transmission does not lock, then there is a problem with the pawl not tngaging and locking the trans.
Always try to adjust the linkage before delving into the trans in cars something is worn, broken or has slipped put of position.
102 views
Usually answered in minutes!
×