I have a 3.0 V6 and I need the intake manifold. Everyone is telling that they are unavailable. Can anyone tell where one is??
Try here:
http://intakemanifolds.org/Ford_Ranger_Intake-Manifold.html?gpc/intakemanifolds.org%2Fwebindex.php%3Fmake%3DFord%26model%3DRanger%26part%3DIntake-Manifold%26src%3Dgpc%26gclid%3DCNTUlbb8q8QCFQiUaQodamYAWQ
SOURCE: Where is the thermostat on my 2.8 V6 engine 1999?
If it's the same as the 99 2.8 V6 in the A4, it's quite a ways inside the front of the engine. You have to remove a lot of the front of the engine and you'll find it partially hidden behind the timing belt tensioner. Foolish place to put such a part unfortunately, but at least on my A4 that's where it is.
SOURCE: O reading for O2 sensors on 98 Ranger XLT
Yes the 98 ranger has 3 02 sensors,they are located in the exhaust system under vehicle,2 of them
are in front of the cataletic converter and 1 behind it.I replaced mine ,reset the codes and the check
engine light still comes on?
SOURCE: 1999 ford crown victoria intake manifold crack
ford made these w plastic water passage no recall need to buy new intake w all aluminum kragens is pretty cheap
SOURCE: when replacing the camshaft sensor
No i will post the procedure below.
3.4L REMOVAL OF CAM SENSOR
1. Turn OFF the ignition.
2. Remove the serpentine drive belt.
3. Disconnect the sensor electrical connector.
4. Remove the power steering pump, if required.
5. Remove the attaching bolt.
6. Remove the sensor.
7. Inspect the sensor for wear, cracks or leakage if the sensor is not being replaced.
To install:
1. Lubricate the O-ring with clean engine oil and replace if damaged.
2. Install the camshaft Position Sensor.
3. Tighten the retaining bolt to 8 ft. lbs. (10 Nm).
4. Connect the sensor electrical connector.
5. Install the power steering pump, if removed.
6. Reinstall the serpentine drive belt.
SOURCE: 2006 ford ranger torque new head bolts and old
what engine? 2.3L 4 cylinder, 3.0L V6, 4.0L V6?
1,126 views
Usually answered in minutes!
×