What is a cam shaft postion sensor and what does it do anjd is nessaceary?

Check the condition of the oil and if it is grey or milky then there is an internal leak allowing water into the oil ( happens from corrosion). Check cooling system level at the radiator. Run fault codes to check cam/crank position sensor anjd it may be necessary to check the cam shaft is turning over as after sitting for some time the cam belt may have deteriated and has broken

yes

The cam shaft postion code is caused by the distrubtor. it is inside of there. Those vehciles had a lot of problems with the ditrubtors.

Do you still have old engine? If so you can use the sencers from it. If not could try the junk yard or dealership

replace crankshaft positon sensor or cam shaft postion sensor they control in what order to fire the spark common issues when a crank postion sensor fails is non start situations


if it helps at all l please leave a good review

are you gettin fuel ? are you getting spark ? if so is it bright blue it should be if its orange is bad
check and replace fuel filter if all that is good check and replace crankshaft postion sensor and or cam shaft postion sensor as they tell the ecu when to fire the spark and to what cylinder


lmk if it helps please give me good feedback

I've had those cam sensors short out the computer in those Jeeps. It's worth a try.

that is a code for cam shaft postions sensor performance

paul
www.carburetorexchange.com

try the ignition switch, or the starter. i had this problem before. 

i will look it up 4 you when i get to work in the morning,which mount ?