Where is the emergency brake indicator switch located?

Check the brake light switch at the brake pedal!

Do you have brake and parkng lights? The turnsignal switch on the column is just designed to relay a path to the flasher and then it is designed to interupt the brake and some of the parking lights lights, which cause the flashing on and off. Double check fuses double check bulb socks and bulbs for good contacts. Does the 4 ways work? If the lights all flash then locate the turn signal flasher and switch with emergency flasher if possible to rule out relay. If those are all good and the emergency flasher lights work and bulbs, then you would have a problem with the turn signal switch. Hope this all helps

What brake are you talking about? The emergency brake or the brake pedal. Warning lights only come on when 1, there is a leak ing the system while driving and you loose pressure, 2. upon starting the vehicle as a bulb check, 3. When you apply the emergency brake. Have the brake switch on the pedal and emergency brake checked also check the bulb. If the bulb lit upon startup, it is probably the switch. Please give more details so that we can be better able to help you.

Those lights rarely burn out. More likely the switch on the brake handle came unplugged. Try grounding the wire from the ebarke switch with the key on.



For the mirrors, I would pull up the control panel and probe for power. Trace the power through the mirror sekection switch, etc.

Pull up on the brake pedal, see if stop lamp goes out? You may need to check stop lamp switch and brake pedal arm? Pull that fuse in diagram, see if it kills the stop lamps? At the bottom left, in diagram, see the green wire with yellow tracer, that wire should not be hot unless you step on the brake. You can use a test light to check for voltage. good luck

on your brake pedal there is a switch that controls your brake lights over time it comes to lose just enough for the switch won't come in contact with the pedal

if the bulbs are good then you may want to check for power at the bulb sockets. the circuit boards on the brake light housing goes bad and looks for ground on an adjacent circuit.

It sounds like the brake switch, that is usually located along the shaft of the brake peddle under the dash, these sometimes are in a bracket for ajustment may not be able to depress switch. Falow starting at peddle go up to dash, you should be able to see it. Hope this helps.

yes they are the same bulbs,sounds like the brake light switch,located where the brake pedal is is not working

check and make sure brake fluid is full, if so then the emergency brake has a switch on it that will make the brake light come on. to check this get in vehicle and push emergency brake then release it then take your hand and wiggle the emergency brake peddle and see if the light comes on and off. if so then the peddle is not comming all the way up against the switch this may be solved by just pulling up on the peddle each time the emergency brake is released,