2001 Chevrolet Camaro Logo
A
Anonymous Posted on Mar 10, 2015

Signals and hazards don't work...does the relay need to be replaced or the flasher??

2 Answers

tml61747

Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 46 Answers
  • Posted on Mar 13, 2015
tml61747
Contributor
Level 1:

An expert who has achieved level 1.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Feb 11, 2009
Answers
46
Questions
1
Helped
17389
Points
96

You can check the fuse panel first. if they both don't work it is possible that the relay has gone out. The hazard switch or fuse is only so that the hazard lights flash properly. Follow up and let me know what you find. TOM

Jim Carus

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 25 Answers
  • Posted on Mar 11, 2015
Jim Carus
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Jul 16, 2011
Answers
25
Questions
2
Helped
5226
Points
50
Ad

5 Related Answers

Anonymous

  • 335 Answers
  • Posted on Jul 31, 2008

SOURCE: Turn Signal Flasher

58940048Its behind the center of the dash under the Ashtray U need TORX screwdrivers to take out the screws got to take off nearly all over the under dash plastic trim.
Contact me if you need more help Thanks

Ad

Anonymous

  • 337 Answers
  • Posted on Dec 03, 2008

SOURCE: locating the turn signal flasher on 1993 corsica

The turn signal flasher is mounted in a clip on the right side of the steering column support bracket. The hazard flasher is located in the component center, under the instrument panel, on the right side. Replace the flasher by unplugging the old one and plugging in the new one.

Anonymous

  • 194 Answers
  • Posted on Dec 05, 2008

SOURCE: Directionals Don't work on 99 Cavalier

under the dash below the steering wheel it is probly blue and round located on one of the courners of the fues box

Anonymous

  • 55 Answers
  • Posted on Mar 07, 2009

SOURCE: No turn signals

Check to make sure none of your turn signal bulbs are burnt out. unlike many cars, these cars will just keep the green arrow on without flashing, instead of the usual rapid flashing that normally happens when a bulb burns out in other cars. Ive had this happen to my Trans Am, and it drove me crazy.

Molson02536

Harvey N Tawatao

  • 3854 Answers
  • Posted on Jun 03, 2009

SOURCE: Constant clicking from flasher unit

The flasher unit has gone bad and needs to be changed. The flasher module is a part of the hazard module also. The clicking is the unit is still working but there is not enough voltage to activate the lights to flash. It's common on the Malibu's and other GM product cars similar to the Malibu like Grand Am's Ect. I believe Auto Zone has the replacement part for you car and is more reasonable in price then the dealer and the y also have the step by step instructions to replace the flasher module. Good luck and keep me posted, be glad to help.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

My turnsignals dont work on my 1987 honda accord flashers do work

flashers and turn signals have separate flasher and separate fuse.
0helpful
1answer

Why dont headlights come on an ford f 250

Hazard and turn signals usually use separate flashers, switch the flashers to see if turn signals work and hazards don't, if so replace the flasher

you need to replace the blinker flasher unit

it is different from the hazard unit

they cost about 4 bucks

the flasher unit is the big round thing in the fuse panel in the dashboard


0helpful
1answer

I need to find the flasher relay for a grand marquis 2001 .does it has one? My turn signals wont work I can hear the sound but don't even flash

Yes, it does have a flasher, although it may be a combined unit with the hazard flashers relay. So you hear the clicking of the flasher relay? That seems to indicate the relay is working properly. Have you checked the bulbs and the turn signal fuse? Any turn signal bulbs light up anywhere, front or back?
How about your brake lights, do they work? Your car may have separate, stand alone turn signals in the rear, but many American cars use the same bulb and same filament on the bulb for the brake lights and turn signals. If your merc is like this and the brake lights work, then the bulb must be good.
Turn on the hazard flashers and see if all bulbs work and flash at each corner of the car. This would be the same bulb as for the turn signals. If they work, it could be a bad turn signal switch, may even be the flasher relay somehow malfunctioning, and in a few cases, a bad hazard switch can affect the turn signal switch. Check fuses and bulbs first. If you have any type of body control module that controls lights and other accessories, you may have to investigate that. I know I'm not being very helpful, just throwing out a few suggestions. Good luck.
0helpful
2answers

My turn signals won't come on at all?

check the fuse if good then turn on the hazard lights if they work then you probably need a turn signal flasher which is a separate flasher unit then the hazard one.it usually looks like the hazard one so with the hazards on and locate it then you will know what the signal flasher looks like and you will also know not to change the wrong flasher unit.the signal flasher is often located at or near the under dash fuse panel or somewhere in the dash you don`t say what type of car your talking about.
0helpful
1answer

The turn signal lights on my 2004 Ford Explorer stay on and don't blink. My hazards flash, but there is no clicking sound of normal use. Eventually, they tend to come back on, or blink with the...

Sounds like your flasher relay is broken. A lot of people think that because their hazard flashers work that everything is OK, this isn't so. Hazard flashers are on a seperate system, and as such they have their own relay.
You will need to find where your indicator relay is located and replace it with the correct type.
2helpful
1answer

I don't know where the signal light flasher is located the signal lights don't flash

Your vehicle has 2 flasher relays. One for the turn signals and one for the hazard lights. The turn signal flasher relay is located on the drivers side, under the dash, mounted on the drivers (Left) side of the steering column. The hazard flasher is mounted on top of the steering column. Do not get them mixed up.
4helpful
3answers

Turn signals dont work on 1993 skylark. all bulbs are good. hazard lights blink fine. turnsignal dash light stays green and doesnt blink

There are 2 separate flasher relays. 1 for the turn signals and one for the hazards. I believe you have a bad flasher relay for the turn signals. The location of that is in the front seating area on the drivers side, under the dash on the drivers side of the steering column, mounted on support bracket. I provided a picture of what it should kind of look like although the picture I gave you is an aftermarket one so the color and such may be a little different but will look the same. Don't get it mixed up with the hazard relay which is located in the front seating area on the drivers side under the dash above the kick pane lmounted on top of the convenience. I am almost 100 percent sure the flasher and hazard relay are the same so if you want to just swap them out in order to have turn signals that should work. You won't have hazards however. I hope this helps you and good luck.


clifford224_215.jpg
1helpful
1answer

How to fix turn signal on 86 Chevy Astro Van

you don`t say but do the lights work either on the front/back on both sides.if not then it may be a fuse that needs replacing or need a bulb replacement.if the lights work but don`t flash then it sounds like a signal flasher problem.the flasher is located in the fuse panel under the dash on the drivers side.if the hazard flashers work then turn them on to find the hazard flasher by the fuse panel then you will know what the signal flasher looks like and change the signal flasher.make sure you change the one for the signals and not the hazard one.if the hazards work then i would say the signal switch is good as the hazards work through the same switch.
0helpful
1answer

Why my emergency flashers work and my signal lights don't

the hazard lights use a different flasher(relay)then the signal lights.you don`t say if the signals work on one side or not,you should check the fuses for the signal lights in the fuse panel under the dash on the drivers side.if you put the hazards on and find the flasher then you will know what the signal flasher will look like,it is on the fuse panel and replace they should work.
1helpful
2answers

Turn signals don't work

i have a similar problem but my left signal works, when i turn the right on it just does an annoying buzz sound. if you can think of any explination for such shinanogins help would be greatly appreciated
Not finding what you are looking for?

70 views

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...