Check to see if the ground on the left side of the transmission is coming loose (not the eyelet but the wire itself) through the wheel well
SOURCE: cooling fan relay placement 05 pacifica
IF YOU OPEN THE HOOD ON THE RIGHT SIDE THERE IS A SQUAR BOX THAT SITS RIGHT NEXT TO THE BATTERY OPEN THAT BOX AND LOOK UNDER THE PART YOU OPEN AND IT HAS A DIAGRAM AND THE NUMBER WHERE IT GOES
SOURCE: 2006 Chrysler Pacifica Auotmatic Liftgate
Yes new gas shocks on the lift gate will fix your problem. I had the same problem on my 2005 Pacifica and when it hit my head- I came up with the solution.
Good Luck,
Ray
SOURCE: How do I adjust the headlights to see further down
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: My 07 Chrysler 300c Oil light comes on,
The warrenty should cover this problem. The oil pressure is a very important part of the powertrain.
As for the engine cutoff, this may be caused by the
powertrain control module shutting down the engine
due to little or no oil pressure to prevent serious
damage. This could be as simple as a bad oil pressure sending unit. But it could also be the oil
pump. In any case I would talk to the crysler dealer
to avoid voiding the warrenty. Hope this helps.
Good luck.
151 views
Usually answered in minutes!
×