P1121, Throttle Position Sensor Inconsistent with Mass Air Flow Sensor.could be a bad throttle position sensor or the electrical wiring to it is bad. and the code po401 is a EGR airflow problem. check the vacuum or electrical wiring for this code. God-Bless!
P1121 Ford Throttle Position Sensor Inconsistent with Mass Air Flow Sensor
http://engine-codes.com/p0401_ford.html no they are not related !
Are there any cracks in the rubber hose from air cleaner to throttle body ! That could cause the P1121 air entering after mass air flow sensor !
P1121 - Throttle Position (TP) Sensor Inconsistent with MAF Sensor
The PCM monitors a vehicle operation rationality check by comparing sensed throttle position to mass air flow readings. If during key ON engine running self-test the comparison of the TP sensor and MAF sensor readings are not consistent with calibrated load values, the test fails and a diagnostic trouble code is stored in continuous memory.
Drive vehicle and exercise throttle and TP sensor in all gears. A TP PID (TP V PID) less than 4.82 % (0.24 volt) with a LOAD PID greater than 55% or a TP V PID greater than 49.05% (2.44 volts) with a LOAD PID less than 30% indicates a hard fault.
P0401 - EGR Flow Insufficient Detected
The EGR system is monitored during steady state driving conditions while the EGR is commanded on. The test fails when the signal from the DPF EGR sensor indicates that EGR flow is less than the desired minimum.
Perform KOER self-test and look for DTC P1408 as an indication of a hard fault. If P1408 is not present, look for contamination, restrictions, leaks, and intermittents
403 views
Usually answered in minutes!
×