SOURCE: 2004 Cadillac XLR
there should be a diagram on the fan shroud cover this will show you the exact way to do this it's a tag that has your firing order on it and the engine size and emmissions info on it as well
SOURCE: Replacing front turn signal bulb on 2006 Cadillac SRX
wow i feel sorry for you because Cadillac designed this bulb to be a don't get to bulb but OK here's what you do take the bottom cover off or skid plastic panel under neath the front end theirs little plastic clips holding it on just get come dikes and don't cut them but just use it to help pull them out. after you get that off use a flash light and locate your light housing you should see two screws holding the house in i think those screws are 8mm i cant remember remove those two screws and be careful the metal from the bumper cuts you pull the light housing out and remove all the screws around the housing and open the housing up replace the bulb and make sure your contact to the bulbs clean and then reassemble the way you took apart. if you cant get it well then best bet is take it somewhere i know Cadillac charges an arm and a leg so you can go somewhere else.
SOURCE: Blinker out on '05 CTS
If you are referring to the maker light on the fender you must remove the plastic wheel well liner panel section. from=nt of wheel well to access the light.
SOURCE: Mechanical problems expeted from 50-100k on a 2005 Cadillac XLR
Your servicing culture determines what your car turns out to be. Service it regulerly and you'll enjoy it
SOURCE: replace front right turn signal bulb
I replaced the front right turn signal on my 2005 Pontiac Montana by reaching up from underneath. I tried removing the battery but the opening from above was too small. I was able to pull the ground effects open enough to get my arm in. When you reach the bulb holder feel for two wings on the bulb socket and give the whole socket a quarter turn to and it will release. The wires are long enough so the entire bulb holder will drop down below the vehicle so you can easily replace the bulb.
Reverse the step to put it back in. You will not be able to see what you are doing so I had someone guide me by watching from above. Took less than 10 minutes once I decided to change the bulb from the bottom. I did not need to jack the vehicle up or use ramps.
82 views
Usually answered in minutes!
×