Where is fuel filter located and where do you check fuel pressure

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

NOTEThe fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cableFuel supply and pressure linesFuel filter bracket, if equippedFuel filter
   

To install:

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm)Fuel filter bracket, if equippedFuel supply and pressure linesNegative battery cable
   
2. Start the engine, check leaks and repair if necessary.

Back to Top

Sorry, there are no parts available for the selected vehicle: 2004 Hyundai Sonata 2.7L MFI DOHC 6cyl.

Ford Focus 2000-05
Removal & Installation

Print

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
   
2. Relieve the fuel system pressure.
3. Raise the vehicle.
   NOTE To remove the lines, press the quick-release tabs on the connectors.
   
4. Remove or disconnect the following:
   
   Evaporative Emissions (EVAP) vapor line Fuel filter lines Fuel filter and bracket assembly Fuel filter
   
   

   Fig. Location of fuel filter and lines.
   
   

To install:

1. Install or connect the following:
   
   Fuel filter Fuel filter and bracket assembly Fuel filter lines EVAP vapor line
   
2. Start the engine and check for leaks.

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE The fuel filter is located underneath the vehicle in the area of the rear suspension.
   
2. Relieve the fuel system pressure.
3. Raise the vehicle.
   NOTE To remove the lines, press the quick-release tabs on the connectors.
   
4. Remove the fuel filter bolt and remove it from the bracket.
   
   

   Fig. Location of fuel filter and lines.
   

To install:

1. Position the fuel filter into the bracket. Ensure the fuel flow direction is properly aligned.
2. Install and tighten the fuel pump bracket bolt.
3. Lubricate the fuel tube fittings with clean engine oil. Align the fuel tube fittings and press together until a click is heard and then pull on the fittings to make sure they are fully engaged.
4. Start the engine and check for leaks

The fuel filter is located under the rear seat.
Fuel Filter Replacement:

1. Reduce the internal pressure of the fuel lines and hoses by completing the following operations:
   • After removing the rear seat cushion, disconnect the fuel pump harness.
   • Start the engine. Allow it to stop by itself, then turn the ignition switch OFF .
   • Disconnect the battery negative (-) terminal.
   • Connect the fuel pump harness connector.
   
   
2. Remove the eye bolts while holding the fuel filter nuts securely.
3. CAUTION: Cover the fuel filter with a shop towel to avoid residual gasoline from splashing.
4. Remove the fuel filter mounting bolts, then remove the fuel filter from the fuel filter clamp.
5. After replacing the fuel filter, check for fuel leaks.

FUEL FILTER LOCATED ON TOP OF FUEL TANK.YOU HAVE TO LOWER TANK JUST ENOUGH TO REMOVE FUEL FILTER.FIRST RELIEF FUEL PRESSURE BEFORE REMOVING FUEL FILTER.TO RELIEF FUEL PRESSURE REMOVE FUEL FILLER CAP.REMOVE FUEL PUMP RELAY FROM THE FUSE AND RELAY BOX LOCATED LEFT SIDE OF THE ENGINE COMPARTMENT. START ENGINE LET IT RUN UNTIL IT RUN OUT OF FUEL.CRANK ENGINE OVER FEW MORE TIMES TO MAKE SURE ALL FUEL OUT OF FUEL LINE.NOW FUEL PRESSURE IS RELIEF.WHEN YOU ARE DONE CHECK FOR FUEL LEAKS BEFORE DRIVING VECHICLE.

FUEL INJECTED ENGINES The fuel filter on fuel injected vehicles may be located in one of two locations. On all 1976–79 vehicles except the Seville, the filter is mounted in the engine compartment near the fuel pump. On the 1976–79 Seville, and all 1980–85 vehicles, the fuel filter is located on the left side of the chassis just ahead of the rear axle. On 1986–89 vehicles, the filter can be found near the frame, in back of the left front wheel. There are two types of fuel filters used on the gasoline fuel injected vehicles, the one-piece disposable inline filter, used on all 1982–86 250 and 1988–89 273 V8 engines, and the replaceable element type filter used on all the other engines. CAUTION
Fuel is under high pressure: if the steps below are not followed, the fuel could spray out and result in a fire hazard and possible injury.

1. Disconnect the negative battery terminal.
2. Release the pressure from the fuel system:
   • Without pressure fitting: Cars without a pressure fitting in the fuel line, cover the fitting to be removed with a shop towel while loosening so that fuel will be absorbed. Dispose of gasoline properly.
   • With pressure fitting: Locate the pressure fitting in the fuel line and remove the protective cap. Loosely install a special valve depressor (G.M. tool no. J-5420) on the fitting. Wrap a towel around the fitting to block any spray and slowly tighten the tool until the pressure has been relieved.
3. Replace the filter as follows:
   1. On the replaceable element type filter; the fuel filter element is replaced by unscrewing the bottom cover and removing the filter element. Replace the element and gasket with an AC type GF 157 or equivalent. Hand tighten the bottom cover.
   2. On the in-line disposable type filter; the fuel filter canister is replaced by loosening the fitting on the end of the filter, then use a pair of pliers to expand the clamp on the other end and slide it down past the point where the hose extends over the inlet of the filter. Gently twist and remove the hose, unscrew and remove the fitting. Remove and discard the old filter. Install the new filter into the hose and replace the clamp. Reinstall the fitting, and check for leaks with the engine idling. NOTE: A dry fuel system on cars equipped with EFI/DFI may require a substantial cranking period before starting. Be sure to crank the engine in short bursts, allowing time for the starter motor to cool between each burst. Fig. 1: Fuel filter location, disposable type — 1986–87 8-250 and 1988–89 8-273 engines
      Fig. 2: Fuel filter location, sealed type — 8-250 and 8-273 engines
      Fig. 3: Common fuel filter location — lower right corner Fig. 4: Removing the fuel filter hose clamp Fig. 5: Removing fuel filter lines — always use a back-up wrench Fig. 6: Removing fuel filter mounting

For 2000 Jeep Grand Cherokee the Fuel Filter is located under vehicle, driver side, below bed area, front of fuel tank, mounted on chassis in fuel line.



Fig. Fuel filter/pressure regulator location-1999-01 models







Fig. Fuel filter/pressure regulator-Grand Cherokee

1. Before servicing the vehicle, please familiarize yourself with safety procedures.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply, return and pressure lines Mounting bolts Fuel filter/pressure regulator

To install:

1. Install or connect the following:
   Fuel filter/pressure regulator to the body. Torque the bolts to 30 inch lbs. (3 Nm). Fuel pressure, return and supply lines Negative battery cable
2. Start the vehicle, check for leaks and repair if necessary.

Gooe luck (remember rated this post).

2002 Hyundai Sonata 2.4L MFI DOHC 4cyl the Fuel Filter is located uUnder vehicle, driver side, below seating area, driver side of fuel tank, mounted on frame in fuel line.


Hyundai Car 1999-05 - Removal & Installation

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:



Fig. Remove the fuel filter

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.
   

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.
   

NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

To install:

1. Install or connect the following:
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
2. Start the engine, check leaks and repair if necessary.

Hope this help to solve your problem.

Sits inside the throttle body, you would have to open to install regulator. Also check your fuel filter make sure it's not clog, fuel filter is under truck on fram rail, while your there do a fuel pressure test, with a fuel pressure tester, should have 13psi.

Please don't forget to rate!!!


NOTE The fuel filter is located underneath the car, near the fuel tank.

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve the fuel system pressure.
3. Remove or disconnect the following:
   
   Negative battery cable Fuel supply and pressure lines Fuel filter bracket, if equipped Fuel filter

Fig. Remove the fuel filter

1. Install or connect the following:
   
   Fuel filter and torque the mounting bolts to 18-25 ft. lbs. (25-35 Nm) Fuel filter bracket, if equipped Fuel supply and pressure lines Negative battery cable
   
2. Start the engine, check leaks and repair if necessary.

To relive the fuel pressure look under hood on drivers side front of engine locate the fuel line where it goes into the fuel rail,trace it back a little ways and you will see a schrader valve for checking fuel pressure. Remove the plastic cap and take something like a small screw driver and press the pin in center to release pressure.
To replace fuel filter you have to remove left front wheel and inner plastic fender panel and fuel filter is located behind this at the back area.