I need to place the fog lighs on my wife's 2007 Odeyssey. Where can I get instrucitons on how to accomplish this task?

good afternoon Anonymous.

The manual for this model can be found here:
https://www.cadillac.com/content/dam/Cadillac/Global/master/nscwebsite/en/home/Owners/Manuals_and_Videos/01_images/2007_cadillac_srx_owners.pdf on the Cadillac website. There is mention on manual page 181 of turning the fog lamps on and off with the Fog Lamp Band. If you look on page 167, it ties an illustration to Fog Lamps, showing you where the band is on the Turn Signal Lever.

Hoping this answers your question!
D

low beam not working could be relay or bad contact at stork control. Fog lights should only work with park lights on. not supposed to be on with headlights like in the movies. This is illeagle in australia to have head lighs and fog lights on together as well as being dangerous to other motorists

salvage yard is your cheepest bet.

There is no "fix". Replacement is required. the transmission must be removed to accomplish this task. Let me know if you need anything else. I may be able to find diagrams of the job if you wish to tackle it yourself.

Check your fog lights sounds like you have a fog light out. DRIVE SAFE TIM

If you want a wiring diagram just ask your Honda dealer service advisor and the will print a copy from their computer may cast a few bucks but cheaper than a complete manual. Now you could just hook on to the low beam wire at the head lite too. Good luck

get under vehicle take off bumper sheilds after that you will need a 100mm get to the fog light and replace /thats it/Please rate my response thank you very much

check your fuses.

o easy enough just jack frontcar up use jackstand for safety now loo up under the bumper where fog lights sit depending on style fog light u might need to pull the whole assembly out or just twist the bulb not a hard task once u see it from underneath it is pretty easy

hi have not had pleasure of this on santa fe yet? but will try to help dependant of which side o/s or n/s ? i would first remove the screws holding the front of the under engine plastic cover/shield and drop down sufficient to gain view/access? to the rear of fog lamp then if a cover is on? try turning anti clock to remove? or if rubber cover pull off? then the bulb and clip should be visible? unplug the wire from bulb then the spring clip holding bulb in place normally just sring the 2x top ends together and swing down/clear to remove bulb? refit new bulb correctly! pay attention to position old bulb positioned? then clip securely and re connect wire at this stage it would be best to ensure bulb works ?? before you re assemble all else? wish you luck and hope this helps with your problem ?