We have a 2010 Dodge Grand Caravan, 6 cyl 4.0 engine, that stalls while driving. Has started to occur within last 2 weeks. Took to dealer and new battery and battery cables and oil change. Drove from dealer and stalled again. Thoughts?

Check the timing , Check the carb is not blocked jet and filter

Have catalytic converter checked

Sounds like you might need to have your fuel filters checked out as well as your fuel pump might be showing signs of going out!

Hi , could you supply the correct engine code and vin number ?
For the engine code (EKG) the firing order is 1-6-5-4-3-2
For the engine code (EGH) the firing order is 1-2-3-4-5-6

The firing order on a 2010 dodge grand caravan v6 is
1 2 3 4 5 6 -easy one to remember ;-))

TxForce

Timing chain or belt is stretched.

If no "check engine" light on, perhaps a new fuel filter would be a good place to start, and have fuel pressure tested if it doesn't help. More info, such as does it only on highway driving, or all the time, when was last tune-up, fuel system cleaned etc?

Verify that your trans fluid is at the correct level. When if at all was the trans last serviced?

If fluid is low, try bringing it up to proper level with Valvoline ATF+4 fluid. You need to used either fluid from a dealer, or the valvoline brand which is approved by Dodge.

------>>>FRONT>>>>of Van >>>>

______________________________
#5 cyl #6 cyl

#3 cyl #4 cyl

#1 cyl #2 cyl
______________________________
_________________
I COIL BLOCK I
I I
I #3 #1 #5 I
I I
I I Firing Order Is
I I 1 2 3 4 5 6
I #6 #4 #2 I
I _______________I_

the Wires Go Accordingly to prospective Terminals, So Sorry Unable to Send Pics through FixYa, A Formating Problem Exists
and they show on my end but not on your end this is TRUE and CORRECT To The BOOK other than the Lines from Coil to Spark Plug ENDS at CYLINDERS. Please dont Forget to RATE Me
Thank You And Happy Motoring!!

It seems like bad,dirty or loose wire harness connection somewhere in electrical circuit. This is very difficult to find if engine has problem intermittently. One method may resolve is to unplug wire contacts one by one inspect clean and re-plug. Inspect also all fuses if any loose seated, nad fuse case connections and support.