I have a 1994 cadillac sedan deville what does right to left bank fueling difference mean and how to fix?? Also what does outside and in car temperature sensor circuit mean and hoW to fix? Please help

SOURCE: 1994 Cadillac DeVille Concourse - Runs rough?

The "check engine" light will "light" when there is a malfunction in the engine management system. The fault code is then stored in the computer. The computer must be scanned to retrieve these stored faults to pinpoint the malfunctioning component. We recommend buying your own scanner and doing it yourself. With a pocket scanner you can check for fault codes to find out why the light came on in the first place. You can clear your cars trouble codes after you replace the malfunctioning sensors.

SOURCE: hey i have a few problems with the cadillac deville 03

change the air fow senser.

SOURCE: 1994 cadillac deville concours

On my car, which is the same as yours, it is located on the manifold top back left. Pictures in the book just show it on top.

honeymokey

• 3113 Answers
• Posted on Aug 03, 2009

SOURCE: When I start my 1994 Cadillac Sedan Deville, The

Replace the ign. lock cylinder and chip key to fix it. The tiny wires to the lock cylinder have broken that ore part of the cylinder. Common problem.

ZJ Limited

• 17989 Answers
• Posted on Sep 24, 2009

SOURCE: how do i cahnge the starter in a 1994 cadillac

1994 Cadillac Deville 4.9L SFI 8cyl

Removal & installation - 4.5L and 4.9L Engines

1. Disconnect the negative battery cable.
2. Raise and safely support the vehicle securely on jackstands.
3. Remove the starter motor shield.
4. Remove the exhaust front and rear pipe assembly.
5. Remove the flexplate inspection cover.
6. Disconnect the solenoid 'S' terminal nut and battery cable nut.
7. Unbolt the starter motor mounting bolts, and remove the starter motor.

1. Install the starter motor, and tighten to 32 ft. lbs. (43 Nm).
2. Install the solenoid 'S' terminal nut. Tighten the nut to 35 inch lbs. (4 Nm).
3. Install the battery cable nut and tighten to 12 ft. lbs. (15 Nm).
4. Install the flexplate inspection cover, the front and rear exhaust pipe assembly and the starter motor shield.
5. Lower the vehicle.
6. Connect the negative battery cable.