How to fix light in gear shift console
SOURCE: change headlight
Behind the low beam and high beam lamps, on the back of the assembly, you can see and feel a round, cup-like, hard plastic piece. This is really just a rubber cap covering a plastic cylindrical housing, and is the "back-door" for lamp access. This rubber cap, or lid, can be pulled off with your fingers...if you can grip it just right and pull off. If this is too hard to do, then take a flat tip screwdriver and gently "pry" it off. Once you see how it is attached, your going to do a 180 and say, "gee, this is a pretty easy design" !
The bulbs do not pull out!! They are removed with a 90 degree twist.
If you are going to replace the passenger side low beam remove the air cleaner assembly first. To do this remove the cross brace, then the 3 screws on the air cleaner assembly. This will give you easy access to the bulb assembly. Test the bulb before you reassemble.
ADDITIONAL OPTION: On each side of the assembly, you will see a small, thin release bar that will pull up (I needed a small pliers to get one loose). Once both are in the "up" position, the entire assembly can be gently eased out. You won't get far because the other bulbs are still plugged in. However, you don't have to unplug any of the other bulbs or remove the air cleaner. Easing out the assembly simply proves more room for your hand to get a better angle at the bulbs. I simply reached around and removed the old bulbs as specified above and did the reverse to insert the new ones.
SOURCE: what does the plus/minus button on the chevy malibu shifter do?
Hi there,
I suppose its a sports mode function where the + enables you to upshift and the - to downshift.
Try using this mode when you are driving as you might like it if you used to drive manual cars before...
Cheers
SOURCE: how to replace headlight bulbs 1999 chevy malibu
Thanks Pierre!
Merci beaucoup!
Everything worked as mentionned. Be carefull with the plastic in the winter. Make sure to use a flat screw driver and get it close to the slider and not on the edge. I cracked one of the tongues. Those L shaped slots are under the plastic cover with the two big plastic plugs that you also remove with the flat screw driver
Pierre Godin, Boissevain Manitoba.
SOURCE: replace headlight bulb
Actually there are two little black tabs on top of each headlight housing and you simply have to pull them up to release the whole headlamp.
Then follow the rest of emissionwiz's solution.
177 views
Usually answered in minutes!
×