I need a diagram for a 1998 Ford Explorer XLT 4.0L V6 SOHC engine wiring harness cause I found bad places in mine and I need to fix them

THAT HAS A HUGE LIST OF CAUSES BUT BREAKS DOWN TO
THE BIG 3. (we find it with tools) otto cycle Gasoline/petrol

• bad engine (compression good?)
• bad spark ( try new cap,rotor , wires and plugs?or 6x coil pack./
• bad fueling or bad fuel. , fuel pressure at spec?

top cause is no tune ups done in 24 years,
all spark parts are bad. (no engine told)
all fuses good/?
test #1 is can you keep it running with a fast right foot actions.
i dies and repeats, or dies and needs to sit for hours to repeat this start fail act./
there were 3 engines then/
4.0 OHV v6
4.0 SOHC v6
5.0 v8 (uses twin quad lug coil packs) and hv wire sets. spark
no engine told so no why to get specific at all just ASE basics basics above.
try a tune up, at least, HV wire sets and new spark plugs gapped right.

and scan scan the PCM see if P03xx errors are stored there.
key on.

Howe's this fer ya?

Search Results

images for 2000 ford explorer 4.0 liter v-6 wiring image


Wiring diagram ford explorer limited 2000 - Ford Explorer and ...

www.explorerforum.com > ... > Stock 1995 - 2001 Explorers

Sep 5, 2012 - 8 posts - ‎6 authors
Wiring diagram ford explorer limited 2000 Stock 1995 - 2001 Explorers. ... 2001 Explorer XLT 4.0L SOHC V6 auto 2WD (RIP 5/13)

Where is the evap purge solenoid on a 1998 ford explorer xlt 4.0 v6 sohc

Camshaft Position Sensor.

make sure your fuel pump is OK first , and let me know .

If thie engine in your explorer is the v6 4.0 I found this information online - You are not supposed to need to replace the timing chain(s) on a 4.0L SOHC V6. There are actually a total of FOUR, on this particular engine. This is a job that I would NOT recommend anyone even thinking of attempting to replace, if it's by anyone other than a FORD DEALER TECHNICIAN FAMILIAR WITH DIASSEMBLY/ASSEMBLY OF 4.0L SOHC V6 ENGINES. The reason for this is because, this particular engine is an interference engine BIG TIME!!! There are NO timing marks on this particular engine. They require FIVE dedicated Ford/Rotunda tools to service.

stop by local parts store (Autozone,Advance, etc) and have them do a free fault code test. They can print out a list of faults and clear the codes

The Engine code should be located on RH Side, Rear, on the Lower Crankcase.

polarcycle is right but there is a speed sensor on the drivers side top of the trans. toward the tail shaft or transfer case. there is as well a sensor inside the trans. itself that is mounted on the web. behind the overdrive band and drum.