Yes there is something in common . Check the fuse # 79 10amp in the underhood fuse box . For O2 sensor , heater power .
The PCM commands the heater ON or OFF to maintain a specific HO2S operating temperature range. The PCM monitors the voltage on the HO2S heater low control circuit for heater fault diagnosis. If the PCM detects that the HO2S heater low control circuit voltage is not within a specified range, DTC P0030 sets for HO2S 1, or DTC P0036 sets for HO2S 2.
So this is not in spec. an it set the other codes !
If the PCM detects that the heater current or the heater calculated resistance is not within an expected range, DTC P0135 sets for HO2S 1
If the PCM detects that the heater current or the heater calculated resistance is not within an expected range, DTC P0141 sets for HO2S 2.
HAD CHECKED THE FUSE FIRST, ITS OK, CHANGED BOTH SENSOR CLEARED CODES DROVE CAR A FEW TIMES , NO CEL YET
THANKS JEFF
Your welcome JIM
×
857 views
Usually answered in minutes!
×