Removing the trim to get at the bulb holder
SOURCE: how to change reverse light bulb on ford fiesta lx 1999
you have to open the boot and go in through that way. you know where the lights are? lift the carpet bit back and you should be able to do it that way. havent tried it myself but going to try and change mine tonite
SOURCE: Fitting brake light - fiesta zetec
There is also a push in socket at the top of the light and a clip at the bottom. When the screws are all undone insert a flat screw driver under the light fitting about 4 inches from the top (remember to use a cloth under the edge of the screwdriver to avoid marking the paintwork) you should be able to push it out now.
SOURCE: 2007 ford 500 rear turn signal bulb replacement
This is straight from the owner's manual.
#1 Make sure the headlamp switch is in the OFF position and open the trunk.
#2 Carefully pull the carpet away to expose the backside of the tail lamp assembly.
#3 Remove the nut and washer assemblies, then pull the lamp assembly away from the vehicle.
#4 Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly.
#5 Pull the bulb straight from the socket.
Install new bulb(s) in reverse order.
Good luck
SOURCE: how to change a headlight bulb on a mk6 ford
remove headlight ,think you have to remove the bumper for this
SOURCE: Y Reg Ford Fiesta Reversing Light Not Working
get under the front end of the car and look near the gearbox there is a plug type cable connection on there unplug it clean it and re connect it will work
Taillight housing
Turn the bulb holder in the direction shown
To install:
Insert the rear light into the cutout in the direction of arrow
166 views
Usually answered in minutes!
×