Cars & Trucks Logo
R
Rob P Posted on Feb 25, 2015
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

2003 Montero Sport 3.0L, 135K miles. Cold start, idle ok. Once warm, low idle and sounds like it has a miss.

Bought OBD II tester. Primary code I believe is P0300 and other codes are P0403, P0113, P0102, P0107. I'm thinking the last 4 codes are a result of the primary code. Never had plugs and wires replaced on it. Problem is my time is limited and looking for a great diagnosis!Its the kids car and every day she is without it is another day I have to be a cabbie

1 Answer

Randy Ohler

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Mitsubishi Master 14,585 Answers
  • Posted on Feb 25, 2015
Randy Ohler
Mitsubishi Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jun 13, 2010
Answers
14585
Questions
8
Helped
3946943
Points
39683

Your going to need a wiring diagram. You have a MAF,MAP, IAT and EGR sensor problem. My guess would be a signal wire or ground is bad. These four sensors are right at the throttle body. The mass air flow sensor and the manifold absolute pressure sensor are one in the same. The intake air sensor is next to it. All are located in the air induction plenum. Between the throttle body and the air filter. The Engine gas recirculation valve/sensor is right behind the throttle body. So check the harness from the air filter/ MAF to the engine harness plug. Look for conduit that is rotted away and/or melted.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2003 Mercury Mountaineer. It runs well while cold but once it warms up, it misses on take off and idles roughly but still runs.

Clean the Throttle Body and Mass Air Flow Sensor. Also check for DTCs (diagnostic trouble codes).

..
0helpful
1answer

Timing for mitsubishi 3.5 montero sport

if it goes when giving gas then i'd look at the tps , get the OBD codes read as may just need a reset
0helpful
1answer

2003 acura tl obd ii code 1740 and 1750

code 1740 refers to AT -4th clutch pressure switch===causes--wiring--range position switch---4th clutch pressure switch---ECM
code 1750 refers to AT-hydraulic system mechanical failure===causes--wiring --shift solenoids--ECM ---transmission mechanical fault.
0helpful
2answers

2003 kia Sedona at a cold start the rpm runs very high and it will take over 2 minutes before its slowly starts to drop.

TPS, IAC, EGR, MAF, MAP. all sensors all having to do with the way the car starts and runs. Does it idle fine after warm up or does the idle jump up and down, or does it go so low sometimes, you think it's going to die on you? I'd look at the TPS and IAC 1st. Go to autozone or advanced auto parts and have then plug the OBD II code reader into your ECU and see if they can pull a code.
0helpful
1answer

My 2002 Mitsubishi Montero will shake real bad at about 40mph/2000rpm's, once your over that speed it will stop. It does not do this when you first start driving and the engine is cold but once it warms up...

This sounds like a wheel balance problem. A local tyre depot will fix in minutes. Try this first before you pay for expensive suspension and steering fixes.
1helpful
1answer

ABS light comes on after 20 miles on Montero Sport 2000. It goes off when car is turned off and then on again after 20 or so miles.  Breaks seem to work fine.

ABS light is turned on when there is an anomoly in the Wheel Speed Sensor data coming to the ABS Brake module.

Have the car scanned by a brake specialist who will have an OBD-II ABS Brake Scan Tool.

If you want to diagnose it yourself, Actron makes a very good one that costs about $99 plus shipping depending on where you get it from.

I bought one with shipping included for $116 off of Amazon.com for my car.

Good luck.

1helpful
1answer

Mitsubishi Montero sport difficult to start when engine is cold. After engine warms up it starts ok. What could be the problem on cold start? Thanks.

possible it could be coolant temp sensor it could think its warm and not supplying enough fuel check eng light on?
4helpful
2answers

On a 2003 mitsubishi montero sport w/ 3.0 v6 a/c belt squeals

Your belt is loose (and it just needs tightening) or it is worn and needs to be replaced. It may look ok but they glaze over; all the little ridges get shinny and slip.
0helpful
3answers

Lifter sound in the morning

check your oil for low level or you probably
need valve adjustment
Not finding what you are looking for?

412 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...