Torque specs for the intake manifold 1998 Cadillac Seville STS

SOURCE: I need fuse box diagram

Goto this website wiring-diagram.com They have full color factory wiring diagrams.
It does cost a few bucks. Not to bad though.

SOURCE: replace power steering pump and lines 1992 cadillac seville sts

you need to have a pulley puller to get the pulley off if you don't have one most auto zone part stores have a loan a tool program and they can help you with that on most powersteering pumps the high pressure line will be a fitting or bolt on and the return line is usually just a squeeze clamp hope this helps good luck

SOURCE: Torque Spec for '99 Chevy C1500 5.7L engine lower intake manifold

On 5.7L engines, install the bolts and torque in sequence as follows:

1. Step 1: 71 inch lbs. (8 Nm).
2. Step 2: 106 inch lbs. (12 Nm).
3. Step 3: 11 ft. lbs. (15 Nm).

SOURCE: 87 samurai bolt torque specs for engine

The haynes book is not recommended since there are numerous mistakes and they still will not update. One of the biggest is the firing order.

The factory service manual is the only way to go.

Head bolts - 46 - 50.5 lbs (there is an order sequence for the bolts)

Intake & exhuast manifolds- 13.5 - 20 lbs

Flywheel - 41.5 - 47 lbs

Clutch cover - 13.5 - 20 lbs

SOURCE: head bolt torque specs for 2000 dodge neon 2.0 SOHC

I have the specs and diagrams. If you want me to send them to you, give me your email address. [email protected]