1999 chevy suburban drivers side seat back removal.
SOURCE: driver side power seat 2001 Chevy Tahoe
as long as nothing is stuck in track and you hear no noise when using switches, look for broken wire at connector or in harness. ck fuse first of course, if blown, something may be stuck in track causing it to stop and blowing fuse
just use a flat screw driver to take it off, it just have a clip inside.
SOURCE: how do I remove the ignition switch on a 1999 chevy suburban?
Ok, start by disconnecting you negative battery cable. From there, wait at least 1 minute to disable your airbag system. You will have to remove the airbag from the steering wheel, it's retained by a couple bolts on the back of the steering wheel. Once you get the airbag out, disconnect the wires to it, and set it aside. Remove the clip that is above the lock nut for the steering wheel, then remove the lock nut. You need a steering wheel puller to pull the steering wheel off. After you remove the steering wheel, you should have access to the turn signal switch.
SOURCE: i am trying to remove my fuel tank from a 96 chevy suburban and replace the fuel pump
ok i'm going to guess that you have a gasoline engine with a side tank like in a pickup truck. if you have a diesel let me know, things might be a little different. here's the step by step for a gas side tank. before you start, disconnect the battery negative cable.
1. drain the fuel from the tank (they don't tell you how, just get as much out as you can)
2.raise and safely support vehicle (get it high enough that you can get under it to work on it)
3.loosen the fuel neck hose at fuel neck and disconnect filler neck from tank
4.support tank and remove tank support straps and insulator strips
5.remove frame mounted bracket
6.lower fuel tank shield
7.lower fuel tank enough to gain access to fuel and electrical connections
8.disconnect fuel feed and vapor hoses
9.disconnect electrical connectors
10.remove fuel sender assembly and seal ring
now to install new tank
1.install NEW seal ring and install sender
2.raise tank enough to connect fuel feed /vapor hoses and electrical connector
3.raise tank fully
4.install fuel tank shield
5.connect fuel tank filler neck and tighten clamp
CAUTION tighten fuel strap fasteners in steps, alternating between straps, until proper torque is reached. failure to properly follow this step can cause bottom of tank to deform. fuel gauge may read improper level if this occurs
6.install fuel tank brackets and insulator strips
torque nuts to 115 in-lbs
7.install fuel tank filler cap
8.connect battery negative cable
9.turn ignition switch off and on and check for leaks
it's pretty much the same for rear tank, just different location, may have off-road shield in back and torque spec is 47 ft-lbs, not 115 in-lbs. you still have to alternate when you torque straps or you risk deforming tank. hope that helps
SOURCE: back seat removal of a 2006 cobalt coupe
are you trying to remove the cushion or the back rest?
203 views
Usually answered in minutes!
×