Question about 2005 Nissan Almera Tino

Open Question

How to fix reversing camera on car.

Screen is blank (black, no picture or wording) when camera is put into reverse gear.

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2920 Answers

SOURCE: automatic transmission

im pretty sure your transmission is going out on the car.you say it wont move in reverse and has hesitation going forward...id say start looking for another transmission or another car

Posted on Jan 18, 2009

Ad
Monster80
  • 463 Answers

SOURCE: Standard transmission will not go into gear!

Does that have a hydraulic clutch pedal or is it mechanical.If you don't know if you pump the clutch pedal about 10 times and you feel it getting harder and you can then put it into gear its hydraulic.Check under the hood on the drives side by the brake reservoir and you should see a little like see through little reservoir with a black cap or rubber cap..Pop that of and see if that is full.If its not than you have a leak in the hose that goes down to the slave cylinder or the slave cylinder is bad..You can look in front of the trans at the bottom as maybe see the leak if one..You can put some brake fluid in that little reservoir.Fill it up the pump your clutch pedal a few times to see if that helps putting into gear while car is running.If all that checks out.Your more than likely going to ned a clutch installed...

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589

Posted on Mar 30, 2009

  • 1 Answer

SOURCE: nissan pulsar 1988 wont go into gear I can put the gear stick in the right gear but does nothing wont reverse or drive, its automatic and has a reconditioned engine in it

try checking your transmission oil (i had the same problem but after $30 it was fixed) it might had drained out. if your transmission oil is fine then consult a mechanic preferebly an automatic transmission specialist. may be your transmission needs a rebuild.

Posted on Jun 09, 2009

  • 1509 Answers

SOURCE: I have no picture on my screen when put into

It's best to check all the fuses and the camera lens for covered with dirt, then follow the wire as it can get pinched near the rear door hinge and then the display can go out too. A true code scanner ( not a code reader ) can look at the body control computer and disnose this problem futher. The back door trim covers the camera and the wires are routed thought the hinge area of the rear door, the control unit is in the right rear under the trim panel and if it got wet it's though. Both of these parts are bank breakers. I recomend a dealer mechanic and ask for an estimate ... you may break good parts and or install parts that don't fix the problem oth could make you upset.. the dealers estimate could make you upset too.

Posted on Sep 17, 2010

SOURCE: 2001 nissan exalta sta/sentra (released in the

Locate the fuse box underneath the drivers side steering wheel and remove the cover lid. Underneath the lid is a diagram of what each fuse controls. Locate the "Stop Lamp" and "Taillight" fuses and pull them out and check them with a fuse test light (avalible at your local auto parts store) Replace the burned out fuse with the same number fuse (the amp number is located on top of the fuse) and your lights will work again

Posted on Sep 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No image , transmitter light comes on in reverse . definetly power to both units .


Troubleshooting Peak Wireless Backup Camera Monitor ...

https://www.etrailer.com/question-8083.html
Troubleshooting Peak Wireless Backup Camera Monitor LED Blinks but No ... Select Your Vehicle .... the blue light on the monitor blinks continuiously and I have no picture on the monitor? ... If so, it will only come on when the truck is in reverse. ... still blinking and you have no picture, then you need to look at the transmitter.

4UCam Backup Camera Test Cases

www.4ucam.com/backup_camera_tests.html
We do not have all different kinds of RVs, tailers and so on for the actual testing. ... for under 30 feet), the 8907T/8908T comes with a transmitter which is detached from the camera. You can fix the ... Wireless Car Backup Camera Series ... reverse gear, thereverse lights go out and the camera stops sending an image. At the ...

Dec 28, 2015 | Cars & Trucks

2 Answers

Why doesn't rear camera work when the car is in reverse?


Either the camera is bogus or power is not getting to the camera when you throw the car in to reverse. Check the power line tap off for the camera- may be by the reverse backup lights..

Nov 18, 2015 | Cars & Trucks

1 Answer

Rear camera black screen when car put in reverse


This tends to faulty wiring or a bad camera. Black screens indicate that no signals are being received.

Mar 04, 2015 | Cars & Trucks

1 Answer

Why porsche cayenne 2009 reverse camera cover is not opening


Is the camera activating? Is the screen going completely black or do you see the measurement marks on the screen when putting it in reverse? Might be a blown fuse, faulty power wire to the camera or simply that the cover is physically stuck by dirt or something.

Aug 17, 2014 | 2009 Porsche Cayenne GTS

1 Answer

Audi A3 reverse lights not working


I don't think any parts are needed, it sounds like a problem that could be fixed with a simple cable or linkage adjustment

Mar 05, 2014 | 2007 Audi A3

2 Answers

Backup camera does not show any display. the warning light comes on but but the screen is black.


The camera at the rear end is not feeding video back to your screen or the screen is dead.

Nov 24, 2013 | 2007 GMC Yukon XL Denali

1 Answer

Mitsu 3000GT Auto Transmission


Im having the exact same problem, word for word, with my 1995 3000gt! Anyone have any ideas on how to fix it please???

Feb 09, 2012 | 1995 Mitsubishi 3000GT

2 Answers

Reverse on my 97 volkswagen jetta


your transmission does not have a synchronized reverse gear. it is an easy fix you just have to remove the transmission (i can do it in about an hour on a hoist) and remove the cover closest to the left side of the vehicle. there you will see that the reverse idler gear is stripped. replace it. clean up the metal shavings and change the trans fluid.

Mar 21, 2010 | 1997 Volkswagen Jetta

Not finding what you are looking for?
2005 Nissan Almera Tino Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...