SOURCE: 2006 Dodge Grand Caravan - EGR code
I replaced the EGR Valve ($80 after tax), problem solved, vanruns great now. Now my problem is that I can't get the light to turn off.
SOURCE: 95 cadillac eldorado engine stalls rough idle check engine light is on
My son has this same car with the same problem. So far after tune up and other process of illimination, the problem points to the catalytic converter. If it is clogged you will get this problem with the rough idle and stalling. Look under the car at night after running it and see if the catalytic glows red. If so you need a new one. Hope this helps.
SOURCE: Service engine code indicates EGR valve.
You could have a restriction in the egr ports. remove the valve. Plug the holes, start engine. 1 hole will be blowing out exhaust, the other will have large vacuum.
SOURCE: FAILED EGR VALVE
The EGR valve helps your car more efficiently and completely burn fuel by recirculating a portion of your exhaust and running it through the combustion process again. This results in a cooler, more complete burn of the fuel which decreases you car's noxious emissions by prohibiting the formation of some harmful gases.
The EGR valve is vital to your car's emission controls.
When the EGR valve goes bad, it must be replaced - it cannot be repaired.
The EGR valve, or Exhaust Gas Recirculation valve, is a vacuum controlled valve which allows a specific amount of your exhaust back into the intake manifold. This exhaust mixes with the intake air and actually cools the combustion process. Cooler is always better inside your engine. The exhaust your EGR valve recirculates also prevents the formation of Nitrogen related gases. These are referred to as NOX emissions, and are a common cause for failing emissions testing. Unfortunately, your EGR valve can get stuck, causing NOX gases to build up. You'll know if your EGR valve is stuck or malfunctioning because your car will experience symptoms like rough idle and bucking on accelertaion.
The only short term problem is a decrease in gas mileage - but it should really be replaced before sensors become sooted or your cat. convertor gets overworked prematurely.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: STOP ENGINE-LOW OIL PRESSURE LIGHT COMES ON AFTER INSTALLING NEW
Before making any repairs I suggest you put an external mechanical oil pressure gauge in place of the sending unit and determine what your actual oil pressure is. That will tell you which way to go using real numbers. If this condition appeared suddenly it may not be a large problem, especially as you did not note any knocking etc that goes along with internal wear.
706 views
Usually answered in minutes!
×