How do i change washer pump on 99 intrepid

Oldsmobile Silhouette Windshield Washer Reservoir ' Used ...

www.partshotlines.com > All Makes > Oldsmobile > Silhouette

Find a quality Oldsmobile Silhouette Windshield Washer Reservoir and other used Mini Van parts ... For example: If you're looking for a Hood Latch, ... This part is also known as Oldsmobile Silhouette Wdsh Washer Reserv; ... 1999 MONTANA

How To Install Replace Windshield Washer Pump Many GM ...

? 2:34
https://www.youtube.com/watch?v=jCqbhK_-hjY
Jun 7, 2010 - Uploaded by 1A Auto Parts
How To Install Replace Windshield Washer Pump Many GM Vehicles ... can u tell Me were the Fuse located ...

The wiper module is mounted on the firewall.

Look at the bottom of the tank where the washer fluid goes. Generally the pump is inside, at the very bottom. There will be a two wire plug and a hose coming out. You replace the whole thing.

on the bottom of the reservour is a hose which is attached to a little pump which makes the washer fluid shoot out on to your windshield.it also has an electrical plug connected to it.sometimes by wiggling the plug it will start to work again,if not,make sure that there is power going to the pump.if there is power,your washer pump will have to be replaced.if there is no power,check your fuses. hope this information helps you with your problem. take care, manny

you can buy a in line pump most anywhere and it just goes in the washer fluid line and the wires from your old pump will need the ends changed to make it work.they come with good instruction.

Try changing the sensor in the resevoir.

check the switch in the bottle

Blower on high only is probably the resistor, on my 99' it was under hood up behind passenger side strut tower, on firewall. 1-1/2"x 3" block or pad with wire connector attached. Pulls out if no sign of bolts or screws holding it. About $20.
Windshield washer pump, can you hear it clicking at all when pushed? You've checked for bad fuse?

Pull the mat back on the upper part of your trunk, there's a little plate with screws in it take it off, you will see the top of the fuel pump unplug it and take the lines off pull the fuel pump up. install the new one. hook up the lines and wiring your done. always be careful when working on fuel related parts

Phil

I would first test your washer pump ( squirter) by a 12 volt source such as battery take 2 wires one for negative and one for positive leads from your battery or other source of 12 volts to the leads on your pump if pump is bad it will not run, you can bypass the switch in the same manner only remove the switch connectors from switch and apply the power to your car connection. Mike